Overview
The Crown Automotive J0940555 is a steering sector shaft seal for the 1966-1971 Jeep Commando. It keeps lubricant in and dirt out where the sector shaft leaves the steering gear housing.
Crown Automotive is a manufacturer and distributor of Jeep replacement parts. Seal material, lip design and dimensions should be compared with the original seal before fitting.
Key features
- Steering sector shaft seal for the 1966-1971 Jeep Commando
- A direct fit replacement
- Crown part number J0940555 identifies the seal
- Part of Crown’s range of replacement Jeep parts
Keeping the sector shaft sealed
The sector shaft seal sits at the point where the shaft exits the steering gear housing. Its job is to hold the gear lubricant inside and keep water and grit out, since both would otherwise work into the gears and bushings. A seal that has hardened or lost its lip will weep oil onto the frame and the inside of the wheel, and it usually gets worse as the lubricant level drops.
When replacing a seal, clean the shaft where the lip rides, because a groove or rust spot will cut a new seal quickly. Install the seal squarely and avoid damaging the lip on the shaft splines. Top up the gear with the lubricant listed in a service manual and watch for seepage over the first few drives.
- Clean the shaft surface where the lip rides
- Install the seal squarely to protect the lip
- Check the gear lubricant level after a few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0940555 |
| UPC | 848399055672 |
| Part type | Steering sector shaft seal |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1966-1971 Jeep Commando, Base model.
Other Jeep models and years are not in the manufacturer list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation involves the steering gear, so follow a service manual for the Commando before starting.
What’s included
Check the quantity and any needed hardware against your installation before starting.









