Overview
The Power Stop S4890 is a front pair of powder-coated performance brake calipers for the 2006–2008 Dodge Ram 1500 and the 2003–2008 Dodge Ram 2500 and 3500. The set holds one left caliper and one right caliper.
Power Stop makes the calipers with enthusiasts in mind and says they bolt in place of the stock front calipers. Caliper and bracket are remanufactured in the USA and finished in a high-temperature red powder coat. New premium boots and seals are installed, silicone lubricant that tolerates heat goes on the pins, and abutment clips are included where applicable. Heavy-duty Ram trucks that tow or plow load the front brakes hard, so a sticking caliper can quickly cause a pull to one side.
Key features
- Front pair with left and right calipers
- Bolt-in replacement for stock calipers
- Remanufactured in the USA, caliper and bracket
- High-temperature red powder coat
- New premium boots and seals
- High-temperature silicone on the caliper pins
- Premium abutment clips where applicable
Heavy-duty front brake care
Front brakes on heavy-duty trucks absorb far more energy than on light pickups. Towing a trailer, hauling a full bed or pushing a plow puts sustained heat into the pads, rotors and calipers, and that heat exposes any caliper that does not release cleanly. Pulling to one side during gentle braking, a pedal that sinks slowly, or a burning smell after a long downhill are early signs of trouble.
Choose pads rated for the loads the truck actually carries, and keep the rotor surfaces smooth. Hoses and fittings deserve the same attention as the calipers, since a soft or swollen hose can hold pressure unevenly. Keep fresh brake fluid in the system, because moisture lowers its boiling point under heavy use and makes pedal feel less consistent.
- Watch for uneven pad wear across the front axle
- Check hoses for swelling or cracks at every service
- Flush old brake fluid on a regular schedule
- Inspect the rotor for heat spots and grooves
Specifications
| Brand | Power Stop |
|---|---|
| Part number | S4890 |
| UPC | 792088848253 |
| Part type | Performance brake calipers |
| Position | Front |
| Set contents | 1 left caliper and 1 right caliper |
| Finish | High-temperature red powder coat |
| Remanufactured in | USA |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2006–2008 Dodge Ram 1500 and the 2003–2008 Dodge Ram 2500 and 3500.
Earlier Ram 1500 trucks are not covered, and Ram trucks from 2009 and newer do not fit this front set. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
These calipers drop in where the stock calipers sat. Because they are used on heavy-duty Ram applications, inspect the front brake hoses and rotors while the system is open, bleed the brakes, and confirm a firm pedal before driving.
What’s included
- Front left caliper and front right caliper
- Caliper brackets, remanufactured with the calipers
- New premium boots and seals
- High-temperature silicone for the pins
- Premium abutment clips where applicable
Not included: pads, rotors, brake fluid and any hardware not listed above.












