Overview
The Crown Automotive J5352278 is a power steering pitman arm for the 1974-1986 Jeep J10 and J20 trucks, supplied as a stock replacement.
On these full-size Jeep pickups, the arm hangs below the steering box and pushes the drag link across the front axle. Over many years the arm can loosen on its shaft or take a bend, and replacing it with a factory-pattern arm is the fix.
It is a stock replacement drop, so it does not correct drag link angle on a lifted truck.
The J10 and J20 were full-size Jeep pickups with their own steering parts. Owners restoring these trucks will find fewer choices, so matching the part number matters.
The J10 and J20 are full-size Jeep trucks that share a front end design, so one arm covers both from 1974 to 1986.
Owners will notice the arm because it is long and heavy compared with CJ parts, as befits a full-size truck.
Key features
- Power steering pitman arm
- Made for J10 and J20 trucks
- Stock replacement amount of drop
- Direct fit
- Covers 1974 through 1986
Steering geometry basics
The pitman arm converts rotation from the steering gear into side-to-side motion through the drag link. Its angle sets how the front wheels track, so a bent or loose arm can cause wander, wheel scrub and a vague steering feel. On older full-size trucks the arm also takes repeated shock from the road, which is why worn splines and a loose nut are common finds at inspection.
When the arm is replaced, the steering box should be centered and the drag link set so the wheels sit straight before the nut is tightened. Taper fits are sensitive to dirt, so clean the shaft and use the correct puller rather than forcing the arm. Check the drag link ends and the tie rod ends at the same time, since worn joints will undo a good alignment soon after the job.
- Check the steering shaft spline for wear
- Inspect the drag link ends for play
- Confirm wheel alignment after the repair
- Tighten the castle nut and fit a new cotter pin
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5352278 |
| UPC | 848399062991 |
| Product type | Pitman arm |
| Amount of drop | Stock replacement |
| Steering type | Power steering |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Crown Automotive J5352278 includes: 1974–1986 Jeep J10 (Base); 1974–1986 Jeep J20 (Base).
It fits the 1974-1986 Jeep J10 and J20. The CJ models and the SJ Cherokee and Wagoneer fall outside this fit. Make sure your year, model and trim match before ordering.
Installation notes
Take the drag link off the old arm, then draw the arm from the steering gear shaft with a puller. With the gear centered, install the replacement, tighten the nut and check the drag link.
What’s included
- One pitman arm, part number J5352278








