Overview
The Crown Automotive 4383471 is an outer brake caliper bushing for front disc brakes on Jeep Cherokee, Grand Cherokee and Wrangler models, including the 1990–2001 Cherokee, 1993–1998 Grand Cherokee and 1997–2006 Wrangler.
A caliper bushing sits between the caliper and its slide pin so the caliper can float as the pads wear. When a bushing hardens or wears, the caliper can stick and wear pads unevenly. Crown Automotive has made and distributed Jeep replacement parts for over 50 years, offering over 8,000 part numbers, including many factory-discontinued items. The same bushing covers three Jeep families over many model years, so it is common to a wide range of older Cherokee, Grand Cherokee and Wrangler front brakes. Replacing worn bushings is a low-cost way to cure a sticking caliper before it ruins a set of pads.
Key features
- Outer brake caliper bushing
- Made for front disc brakes
- Direct fit listing
- Covers Cherokee, Grand Cherokee and Wrangler
- Crown Automotive replacement part for Jeep vehicles
Signs the bushing is worn
A worn caliper bushing usually shows up as a caliper that drags, pulls to one side, or heats the rotor more than the other wheel. Uneven pad wear on one side and a pad that sticks against the rotor are common early signs. Because the bushing controls how the caliper floats, a sticking caliper can also wear the slide pin and its boot faster than normal.
When the bushing is replaced, the slide pin and the inner bushing should be checked in the same job. Clean old grease from the pin, apply fresh caliper grease, and make sure the caliper moves smoothly by hand before reinstalling the wheel. Pads and rotors often wear unevenly after a caliper has been binding, so inspect them before reusing them. A short road test after the job will show whether the caliper releases properly.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4383471 |
| UPC | 848399003666 |
| Part type | Outer caliper bushing |
| Applies to | Front disc brakes |
| Fit type | Direct fit |
Vehicle fitment
The 4383471 fits the 1990–2001 Jeep Cherokee, the 1993–1998 Jeep Grand Cherokee and three Wrangler ranges: 1990–1995, 1997–2006 and 2004–2006. Those Wrangler ranges correspond to the YJ, TJ and LJ. The three Wrangler ranges overlap, reflecting how the fitment was compiled by year rather than by body style, so a TJ owner will find the 1997–2006 entry and an LJ owner will also see 2004–2006.
It does not fit the 2007 and newer Wrangler or the 1999 and newer Grand Cherokee. It is for front disc brakes only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Bushings work with the caliper slide pins, so inspect the pins and the matching inner bushing whenever you replace an outer one. Keep the slide surfaces clean so the caliper can move freely. Check that the outer bushing seats fully in its bore, and replace the paired inner bushing at the same time if it is worn.
What’s included
- One outer caliper bushing, part 4383471. Confirm the quantity in your package before starting.
Not included: the caliper, slide pins, brake pads or rotor.









