Overview
The Crown Automotive NP231 input bearing retainer kit, part number 4338972, provides an input bearing retainer and seal for NP231 transfer cases. It fits 1987–1996 Jeep Cherokee (XJ), 1987–1992 Jeep Comanche and 1987–1995 Jeep Wrangler (YJ).
The kit includes a seal and a bearing retainer, and it is a direct fit for the vehicles below. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Kit includes seal and bearing retainer
- Designed for the NP231 input bearing area
- Part 4338972 from Crown Automotive
- Fits XJ, Comanche and YJ Jeep models from 1987 to 1996
Input bearing area wear
The input area of a transfer case is where the shaft enters, carries the bearing and sits behind the seal. A retainer holds the bearing in place, while the seal keeps lubricant inside as the shaft turns. Over time, heat and age can harden the seal, and a bearing that has moved in its bore may cause noise or leakage.
When this area is open, inspect the bearing race, the retainer bore and the seal surface for scoring or looseness. Clean all mating faces before fitting a new seal, and use fresh gasket material where the retainer meets the case. Pay attention to the lubricant level after assembly, since a low level can shorten bearing life quickly.
- Check the bearing race for scoring
- Clean the retainer bore before fitting
- Check lubricant level after reassembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4338972 |
| Part type | Input bearing retainer kit |
| Transfer case | NP231 |
| Included | Seal and bearing retainer |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1987–1996 Jeep Cherokee (XJ) in Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims; 1987–1992 Jeep Comanche in Base, Chief, Eliminator, Laredo and Pioneer trims; and 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
The list does not include 1997–2001 Cherokee XJ, Grand Cherokee or Wrangler TJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The retainer and seal sit at the transfer case input, so fitting this kit means opening the case. A qualified shop should set the new seal and check for leaks afterward.
What’s included
The kit contains a seal and a bearing retainer. Check the package contents against your transfer case service needs before installing.










