Overview
The Crown Automotive J3225201 is a harmonic balancer damper for the 4.2L engine with V-belt drive. It fits Jeep CJ, Cherokee SJ, Wagoneer, Scrambler, Grand Wagoneer and J-series vehicles, with years and trims covered below.
A harmonic balancer damper sits on the front of the crankshaft and reduces torsional vibration, the twisting motion produced by the engine’s rotating parts.
Key features
- Built for the 4.2L engine with V-belt drive
- Harmonic balancer damper reduces crankshaft torsional vibration
- Listed across CJ, SJ and J-series Jeep models
- Crown Automotive part number J3225201 with UPC
Why the damper matters
The harmonic balancer damper reduces the twisting vibration that builds along the crankshaft as the engine fires. Without it, that vibration can wear bearings, loosen the pulley and stress the belt. The damper uses an outer ring bonded to a rubber layer, and the rubber does most of the damping work as it flexes with each pulse.
Replacement is easier when the job is planned. Removing the belt and pulley gives access to the damper, and the crankshaft should be kept from turning while the bolt is loosened. Before fitting the new unit, check the crank snout and key for wear, and make sure the pulley lines up with the old marks or the belt will run out of track.
- Check the crank snout and key for wear
- Confirm pulley alignment before tightening
- Keep the crankshaft from turning during removal
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3225201 |
| UPC | 848399060058 |
| Engine | 4.2L with V-Belt |
| Part type | Harmonic balancer damper |
Vehicle fitment
It fits 1975–1983 Jeep Cherokee (SJ), CJ5, DJ5, CJ6 (1975), CJ7 (1976–1986), 1984–1986 Grand Wagoneer (SJ), 1975–1987 J10, 1976 J20, 1981–1985 Scrambler, 1980–1983 Wagoneer (SJ) and 1987–1990 Wrangler (YJ).
Grand Cherokee, Comanche and Cherokee XJ models are not on this list, and the Wrangler YJ entry covers only the years shown. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a damper usually means removing the drive belt and crankshaft pulley first, so plan for that before the old unit comes off.
What’s included
The harmonic balancer damper only. Check for bolts and a seal against your installation before starting.









