Overview
The Crown Automotive front brake hose is a rubber replacement hose for 10 inch brakes, and it is a direct fit for stock height vehicles with 0 to 2 inches of lift. Crown Automotive makes and distributes replacement Jeep parts.
The hose is labeled as a front brake hose. Check the brake size and hose position before installing, because no model or year is attached to the hose.
Key features
- Rubber hose construction
- Front position
- Built for 10 inch brakes
- Direct fit at stock height, 0 to 2 inches
Stock height and brake size
Brake hose length and routing depend on suspension height and caliper location. At stock height the hose runs with less slack than on a lifted truck, so the route should be checked with the wheels turned and the suspension at full travel. A hose that is too short can strain at the fitting, and one that is too long can rub on the tire or frame.
Rubber hoses wear with heat, age and road debris, so inspect them at every brake service. Look for cracks, bulging, rubbing and seepage at the fittings. Brake fluid should be wiped from paint at once, since it can damage finishes. After any hose change, bleed the system and test the pedal at low speed before driving normally.
- Inspect hose routing at full steering lock
- Check for rubbing on frame and tire
- Replace hoses that show bulging or cracks
Specifications
| Brand | Crown Automotive |
|---|---|
| UPC | 848399055375 |
| Material | Rubber |
| Position | Front |
| Brake size | 10 inch |
| Lift range | 0 to 2 inches (stock) |
| Fitment type | Direct fit |
Vehicle fitment
Vehicle details for this Crown hose stop at a stock-height direct fit, with no Jeep model, year or trim named.
Lifted vehicles above 2 inches sit outside the stated range. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Compare the fittings and the 10 inch brake size with the hose you are replacing. Brake fluid can damage paint, so wipe up any spills during the swap.
What’s included
This is a single front brake hose. Check whether clips, fittings or hardware are needed for the swap before starting.








