Overview
The Crown Automotive 5012851AA is a rear driver side axle shaft for the Dana 44, with 30 splines. It fits 1999–2004 Jeep Grand Cherokee (WJ) models in Laredo, Limited, Overland, Special Edition and Sport trim.
The shaft is the rear left unit with driver side location.
Key features
- Rear driver side shaft
- Dana 44 axle type
- 30 splines
Before you buy
The rear axle shaft on a Dana 44 carries power from the differential to the rear hub, and it is exposed to road debris and suspension articulation at every turn. On a WJ Grand Cherokee the shaft’s splines must match the differential side gear exactly, so a shaft with the wrong count will not engage. Check that the axle type matches before buying, since shafts for different Dana axles are not interchangeable.
Replacing a rear shaft is a good time to inspect the axle seal, the pinion seal and the wheel bearings, because any of them can leak or wear once the axle is opened. Shafts usually fail through worn joints, bends after an impact, or a torn seal that lets dirt into the bearing. Listen for clicking on turns and check for fluid on the inside of the wheel.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5012851AA |
| Axle maker | Dana |
| Axle location | Rear |
| Axle shaft location | Driver side |
| Position | Rear left |
| Axle type | Dana 44 |
| Axle spline | 30 splines |
Vehicle fitment
It fits 1999–2004 Jeep Grand Cherokee (WJ) in Laredo, Limited, Overland, Special Edition and Sport trim.
The bullets give the Dana 44 axle type and 30 splines.
Compare the 30 splines and Dana 44 axle type with the shaft being replaced before fitting.
The list covers the 1999–2004 WJ years only, so other Grand Cherokee generations are not on it.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear driver side axle shaft.








