Overview
The Crown Automotive J8126638 is a Dana 44 axle shaft universal joint, a large Dana 30 type joint, for the front driveshaft-to-axle position. It is built for vehicles with ABS and has a heavy duty forged cross with an inside snap ring to hold it in place.
It is an O.E.M. replacement with Perma-lube seals for longer service life. It is a direct fit for several Jeep models across the XJ, YJ, TJ, LJ and JK generations, so check the fitment details below against your vehicle first.
Key features
- Dana 44 axle shaft universal joint, a large Dana 30 type joint
- Built for vehicles with ABS
- Heavy duty forged cross
- Perma-lube improved seals for longer service life
- O.E.M. replacement design
- Inside snap ring
Inspecting axle shaft joints
An axle shaft universal joint carries the full angle of the axle and transmits wheel torque, so it is among the first parts to show wear on a heavy-use Jeep. Look for clicking on turns, vibration under load or grease leaking past the seals. Because the snap ring holds the cross in the yoke, a loose or damaged ring is a safety concern and should be fixed before the vehicle is driven.
Check that the cross moves freely in each cup and that the cups are not pitted. Clean the yoke and the snap ring groove before fitting the new joint, and make sure the ring seats fully. Since this joint is not lubeable, the seals and clips are the parts to check at installation, not a grease schedule.
- Check the snap ring seats fully in its groove
- Inspect the cups for pitting before fitting
- Look for leaking seals after the first drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8126638 |
| UPC | 848399068504 |
| Position | Front driveshaft at front axle |
| Cup size | 1.188 inches |
| Snap ring to snap ring size | 2.188 inches |
| Lubeable | No |
| Highway rated | Yes |
| Snap ring type | Inside |
Vehicle fitment
This joint fits five Jeep groups: the 1992-2001 Cherokee (XJ), the 1997-2006 Wrangler (TJ), the 2004-2006 Wrangler (LJ) Unlimited, the 1993-1995 Wrangler (YJ), and the 2007-2012 Wrangler (JK). It covers models with a range of trims and body styles.
Years outside those ranges, including the 2013-2018 JK and the later JL, are not covered. The joint is a Dana 44 type, so confirm the front axle and snap ring size before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The inside snap ring and the 2.188 inch snap ring to snap ring size must match the axle shaft you are fitting. Since the joint is not lubeable, check the seals and clips at installation before the shaft goes back in.
What’s included
One universal joint with its inside snap ring.








