Overview
The Crown Automotive differential shaft pin, part 5252502, is a threaded standard pin for a Dana 44 rear differential. It fits the 1990–2001 Jeep Cherokee (XJ), the 1999–2004 Jeep Grand Cherokee (WJ) and the 1993–1998 Jeep Grand Cherokee (ZJ).
It also fits the Wrangler YJ, TJ and LJ. Compare the threaded style with the pin you are replacing before installing.
Key features
- Threaded style
- Standard pin for the Dana 44 differential
- Rear position
- Part number 5252502
Pin wear and replacement
A differential shaft pin locates the shaft within the carrier, so its condition affects how the axle shaft sits and how the carrier bore holds it. A worn pin can allow the shaft to walk, which may cause noise, vibration or a loose feel at the wheel. Threads and the mating bore should be checked as part of any axle service.
When replacing the pin, inspect the carrier bore and the retaining hardware for damage. A bore that has been worn oversize may need repair before a new pin will hold properly. Threads that are cross-threaded or stripped will not seat correctly, so clean them and check the fit before final tightening.
Use the correct locking method and torque for the pin, and confirm the pin is fully seated after the first drive.
- Check the threads for damage before installing
- Inspect the carrier bore for wear
- Confirm the pin is fully seated after the first drive
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5252502 |
| UPC | 848399010435 |
| Pin style | Threaded |
| Pin type | Standard |
| Axle | Dana 44 |
| Position | Rear |
Vehicle fitment
It is a direct fit for the 1990–2001 Jeep Cherokee (XJ), the 1999–2004 Jeep Grand Cherokee (WJ), the 1993–1998 Jeep Grand Cherokee (ZJ), the 2004–2006 Jeep Wrangler (LJ), the 1997–2006 Jeep Wrangler (TJ) and the 1990–1995 Jeep Wrangler (YJ).
The Wrangler JK and JL are not on this list. Confirm your vehicle’s year, model and trim before ordering.









