Overview
The Alloy USA 11502 is a Super Dana 44 X-Joint, a heavy-duty replacement for the factory U-joints on Rubicon Dana 44 axle shafts. It is a direct replacement for the factory U-joint and is made for 2-door and 4-door Rubicon models.
Alloy USA makes the X-Joint from 8620 case hardened alloy steel and adds features for off-road use. Each forged bearing cap has its own grease Zerk for lubrication, and triple ridge seals are used to keep dirt and contaminants out of the bearings. The joint comes with the full set of retaining clips and grease fittings.
Key features
- Heavy-duty X-Joint, a direct replacement for the factory U-joint
- 8620 case hardened alloy steel construction
- Forged bearing caps, each with an individual grease Zerk
- Triple ridge seals to keep out dirt and contaminants
- Four 360-degree retaining clips and four 180-degree retaining clips
- Four grease Zerk fittings included
Driveline joint care
A U-joint lets the driveshaft change angle as the axle moves up and down, so the joint is always under load and always moving. Heavy-duty joints are built to carry more torque and to handle the extra articulation of a lifted or off-road vehicle. Their life depends on steady lubrication, clean seals and clips that hold the bearing caps firmly in place.
Check the joints at regular service intervals and whenever the driveline is removed. Look for grease leaking from the seals, rust on the caps, and play that you can feel when rocking the driveshaft by hand. A joint that is starting to fail often makes a clicking or vibrating noise under power, so address it before it turns into a broken driveshaft on the trail.
- Grease each bearing cap until fresh grease shows at the seal
- Check retaining clips after the first few drives
- Inspect seals for cracks or leaks
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 11502 |
| UPC | 804314269036 |
| Product | Super Dana 44 X-Joint |
| Material | 8620 case hardened alloy steel |
| Seals | Triple ridge |
| Retaining clips | Four 360-degree, four 180-degree |
| Grease fittings | Four Zerk fittings, one per bearing cap |
| Models | Rubicon, 2-door and 4-door |
Vehicle fitment
It is made for Rubicon models with a Dana 44 axle, in both 2-door and 4-door form. Fitment is determined by axle and model.
It is designed for Rubicon models only. Measure the joint and axle, and confirm fit for your vehicle’s year, model and trim before ordering, especially on any Dana 44 that is not a Rubicon.
Installation notes
Each X-Joint has to be installed with its retaining clips in place, and the grease Zerk on each bearing cap should be checked after installation so the bearing receives grease. Lubricate the new joint before the axle is put back into service.
What’s included
One X-Joint with four 360-degree retaining clips, four 180-degree retaining clips and four grease Zerk fittings.













