Overview
The Crown Automotive Dana 35 Rear 3.07 Ratio Ring and Pinion, part number CRO83505472, is a rear ring and pinion gear set with a 3.07 gear ratio for the Dana 35 rear axle. It fits the 1987–2000 Jeep Cherokee (XJ), 1997–2000 Jeep Wrangler (TJ) and 1987–1995 Jeep Wrangler (YJ).
Ring and pinion gears come as matched sets, so the ratio and axle type must agree with the carrier they go into. This is a rear axle part for Jeeps driven on and off road.
Key features
- 3.07 gear ratio
- Dana 35 rear axle application
- Each part is tested on Jeeps before it reaches dealers.
- Crown backs its line with a 12 month/12,000 mile warranty
Gear set setup and break-in
Setting up a ring and pinion is precise work. The installer checks pinion depth, backlash and bearing preload, since small errors lead to whine, heat and early wear. Those checks usually mean the carrier comes out of the housing and the contact pattern is verified, so the job takes longer than a simple bearing swap.
Gears benefit from a gentle break-in period. Keep speeds and loads moderate for the initial driving, avoid hard launches and heavy towing, and listen for changes in noise. Check the gear oil level after the first drives, and inspect axle seals and bearings for seepage or play as the set settles in.
Ratio choice depends on tire size and how the truck is used. Larger tires or heavy loads change how the gears feel, so match the gear choice to the whole drivetrain. Gears are often replaced with new bearings, seals and pinion shims, so plan the full job before starting.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | CRO83505472 |
| Axle type | Dana 35 |
| Position | Rear |
| Axle location | Rear |
| Gear ratio | 3.07 |
| Axle manufacturer | Dana |
Vehicle fitment
It fits the 1987–2000 Jeep Cherokee (XJ), 1997–2000 Jeep Wrangler (TJ) and 1987–1995 Jeep Wrangler (YJ), with trims for each model.
Wrangler JK and Cherokee KJ are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion gears are normally installed by a professional who sets pinion depth, backlash and bearing preload. Gear sets need a break-in period, so ask your installer for the recommended procedure.
What’s included
The set is the ring and pinion gears. Check the package contents for pinion bearings, shims and carrier hardware before starting, since those parts may need to be sourced separately.









