Overview
The 83502880 is a Dana 35 rear differential case assembly, without ABS, built for a 3.07 ratio. It fits the 1987-1993 Jeep Cherokee (XJ) and the 1987-1995 Jeep Wrangler (YJ). The case holds the gears and bearings for the rear axle, so it is a complete replacement case rather than a single gear.
It is a direct fit in the rear position. Part number 83502880 is part of the Jeep replacement range.
Key features
- Dana 35 differential case assembly
- Built for a 3.07 ratio
- Listed without ABS
- Rear position, direct fit
Rebuilding the differential
A differential case carries the spider gears, side gears and carrier bearings, so it is worn as a unit when the internal parts wear. Before fitting a new case, check the bearing seats, the bearing caps and the bolt holes for wear or damage. Fitting new bearings during the same job helps keep the carrier running true.
Gear setup matters more than the case itself. Tooth contact pattern and backlash should be set during reassembly, and the pinion depth must match the ratio. Use the lubricant recommended for the axle and confirm the ABS setup before the axle goes back into the vehicle.
- Check the carrier bearing seats for wear
- Replace the carrier bearings when they are removed
- Set backlash and tooth contact during reassembly
- Confirm the ratio and ABS setup before installing
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502880 |
| UPC | 848399024883 |
| Axle | Dana 35 |
| Ratio | 3.07 |
| ABS | Without ABS |
| Position | Rear |
Vehicle fitment
It fits the 1987-1993 Jeep Cherokee (XJ) in its Base, Briarwood, Chief, Country, Laredo, Limited, Pioneer and Sport versions. It fits the 1987-1995 Jeep Wrangler (YJ) in its Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport versions.
The years end at 1993 for the Cherokee and 1995 for the Wrangler. The later XJ years to 2001 and the TJ Wrangler fall outside this range. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Check the pinion and carrier setup against the 3.07 ratio before the axle goes back together.
What’s included
One Dana 35 differential case assembly.
Not included: Axle shafts, bearings and the ring and pinion are not part of this case.








