Overview
The Crown Automotive rear case half, part number 4886373AA, is a replacement rear housing section for the NP242 transfer case. It carries UPC 848399030648.
Crown Automotive’s Jeep replacement catalog runs to over 8,000 part numbers, and this case half is one of its transfer case components.
Rebuild planning
A transfer case rear half holds part of the gear and shaft assembly, so replacing it is a job that touches most of the internal parts. Before starting, lay out the new and old parts, clean the mating surfaces and check the internal shafts and gears for wear, scoring or damaged teeth. Planning for the full set of gaskets, seals and fasteners avoids stopping partway through the job.
Mating surfaces need clean, flat contact to seal properly, so remove old gasket material carefully and avoid gouging the aluminum. Inspect the bearings and seals at the same time, since they are easier to replace while the housing is open. Keep fasteners organized by location, and tighten them in the sequence called for in the service procedure.
- Clean and inspect mating surfaces
- Check shafts and gears before reassembly
- Replace seals and gaskets while the case is open
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4886373AA |
| UPC | 848399030648 |
| Component | Rear case half |
| Compatible transfer case | NP242 |
Vehicle fitment
Confirm the NP242 match on your transfer case before ordering, since the case half must suit that unit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a case half means opening the transfer case, so the internal gears and shafts need careful handling. Work from an NP242 service manual during the job.
What’s included
Check the package contents against your installation before starting, including gaskets, bolts and internal transfer case parts.









