Overview
The Crown Automotive J3227849 is a brake hose washer that seals the connection between the brake hose and the caliper. It fits the 1978–1981 Jeep CJ5 and CJ7 and the 1981 Scrambler. It sits between the hose end and the caliper.
Crown Automotive builds replacement parts for Jeep vehicles, and this is a small hydraulic hardware item that is worth renewing whenever a brake hose is disconnected.
Key features
- Hydraulic brake washer for the brake hose to caliper joint
- Direct fit for the listed CJ5, CJ7 and Scrambler years
- Replacement hardware from Crown Automotive
Renewing the hose washer
A brake hose washer is a small sealing ring at the point where a flexible brake hose meets the caliper. Its job is to keep brake fluid from weeping at that joint while the system carries pressure. When a hose is disconnected for a caliper rebuild or line repair, the washer is worth inspecting closely, and in most cases a fresh one is the safer choice at reconnection.
Washers can flatten or take a set after the first tightening, which is why a reused one may seep even though it looked sound. After reconnecting, tighten the banjo bolt to the value in your service manual, bleed the system, and have a helper hold the pedal firm while you check the joint for fluid. Recheck the joint over the next few drives, since a small leak often shows up after the first heat cycles.
- Inspect the sealing faces for scoring or distortion
- Use a new washer on each reconnection
- Check the hose for twisting once it is tightened
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3227849 |
| UPC | 848399060195 |
| Part type | Brake hose washer |
| Used between | Brake hose and caliper |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1978–1981 Jeep CJ5, the 1978–1981 CJ7 and the 1981 Scrambler.
Other CJ years and later CJ7 and Scrambler years are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.









