Overview
The Crown Automotive J3223416 is a brake caliper screw for the driver or passenger side front of the 1976–1981 Jeep CJ5 and CJ7 and the 1981 Scrambler.
A caliper screw fastens the front brake caliper to its mount. This screw fits the front position, on either the driver or the passenger side.
It is offered as a direct fit replacement for the years shown below.
Caliper screws carry real load, because they hold the caliper against braking torque. The J3223416 fits the front position on either side of early CJ5, CJ7 and Scrambler models. Compare its length, thread and grade with the original screw before fitting. Replacing worn or damaged screws is sensible when the caliper is off.
Key features
- Brake caliper screw
- Driver or passenger side front
- Front position
- Direct fit
Caliper screws and torque
Caliper screws sit in a high-load position, so their condition matters more than their cost suggests. A stretched, corroded or rounded screw can let the caliper move under braking, which shows up as clunking, uneven pad wear or a pulsing pedal. Early CJ and Scrambler calipers have been in service for decades, so the mounting bores and threads may be worn as well as the screw.
Clean the threads and the mounting surface before installing the new screw, and avoid grease or anti-seize unless the service instructions call for it. Tighten the screw to the specification in your workshop manual rather than by feel, and recheck it after the first few drives. Replace the pads and check the rotor for runout while the caliper is off, since those jobs often happen at the same time.
- Look for stretched, corroded or rounded threads
- Clean the threads and caliper mount before fitting
- Tighten to the workshop manual specification
- Recheck the screw after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3223416 |
| UPC | 848399059892 |
| Part type | Brake caliper screw |
| Position | Front |
| Side | Driver or passenger |
Vehicle fitment
It fits these vehicles:
- 1976–1981 Jeep CJ5 (Base, Golden Eagle, Laredo, Renegade)
- 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade)
- 1981 Jeep Scrambler (Base)
The list covers 1976–1981 CJ5 and CJ7 models and the 1981 Scrambler. Later CJ years, the Wrangler and the Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The screw holds the caliper in place, so a qualified technician should fit it and the brakes should be tested before regular driving.
What’s included
One caliper screw, part number J3223416.
Not included: calipers, pads and other brake hardware.









