Overview
The Crown Automotive axle locker sensor connector, part number 68003570AA, is a factory replacement connector for an axle locker sensor circuit. Connectors join the sensor wiring to the vehicle harness, so the plug type must match the sensor and harness it is used with.
The Crown Automotive axle locker sensor connector, part number 68003570AA, is a factory replacement part with a universal fit tag. Compare the connector with the original one before use.
Connector care and repair
A connector joins the sensor wiring to the harness, so the plug shape, pin layout and wire crimps all need to match. The most common problems are corrosion on the pins, cracked housings from heat or abrasion, and loose wire terminals that work out over time. Inspecting the connector is often quicker than replacing the whole sensor circuit.
Disconnect the battery before unplugging any locker wiring, and keep the connector dry during installation. Use dielectric grease on the terminals to slow corrosion, and make sure the latch seats fully so the plug does not back out on rough trails. If a connector shows green build-up or melted plastic, trace the wiring back and replace the damaged section rather than just the plug.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68003570AA |
| Type | Factory replacement part |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. Compare the connector with the original one before ordering.
Confirm your vehicle’s year, model and trim before ordering.








