Overview
The Jeep actuator connector, part number 68003570AA, is a factory replacement connector in the differential switches and shifters group. It fits 2 and 4-door Jeep models with a Dana 44 front or rear axle.
Compare the connector with your own Jeep’s door count and axle before ordering.
Key features
- Factory replacement part
- Noted for 2 and 4-door models
- Noted for Dana 44 front or rear axle
- Universal fit.
Actuator wiring and locker function
A differential actuator is a switch-controlled part that engages or releases a locker or disconnect. Its job depends on a steady electrical signal, a clean ground and a sound harness, so the wiring should be checked along with the part itself. Problems often start at the plug, where moisture and corrosion collect.
Before replacing an actuator, check the fuse, the switch and the wire routing near the axle, which can chafe on the driveshaft or frame. Unplug the connector, inspect the pins and seal, and clean them with electrical contact cleaner. Test operation before reassembling the trim.
- Inspect wire routing for chafing near the axle
- Clean and dry connector pins before reconnecting
- Check fuses and the switch before replacing the actuator
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68003570AA |
| UPC | 68006570AA |
| Category | Differential switches and shifters |
| Models noted | 2 and 4-door |
| Axle noted | Dana 44 front or rear |
| Fitment listed | Universal fit, no years named |
Vehicle fitment
Compare your Jeep’s door count and Dana 44 axle with the connector before installation. Universal fit applies, so confirm model years on your own vehicle.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The connector is the only item supplied. Check the package contents against your installation before starting.











