Overview
The Low Range Offroad Rear Electric E-Locker Switch, part number LRODIY-ELSR, is a DPDT switch for wiring a rear Toyota Electric E Locker yourself. Its DPDT design suits the do-it-yourself wiring for these lockers.
The switch runs separately from the factory Toyota wiring rather than through the factory e-locker computer. A short harness to the differential is required, and splicing 6-lead trailer wire into the factory differential harness is a common approach.
Key features
- DPDT (double pole double throw) switch, with two circuits that each change between two positions
- Written for the rear Toyota Electric E Locker
- Wired separately from the factory Toyota wiring
- Not intended for the factory e-locker computer
Wiring a separate locker switch
An electric locker switch sends power to the locker’s actuator, so the wiring plan matters as much as the switch itself. Running the switch on its own circuit keeps the factory e-locker system and its diagnostics from being affected by the added wiring, and it makes troubleshooting simpler if the locker stops engaging. Take the time to map the circuit on paper before cutting anything.
Before wiring, confirm the switch position, the harness length and the route away from moving suspension parts, heat and water. Secure the harness with clips so it cannot rub on the axle or the frame, and test the switch with the vehicle stationary before driving. Keep a record of the splice points so a future repair does not require tracing the whole run again.
- Route the harness away from exhaust and moving parts
- Use a fuse on the power feed
- Secure the wire with clips at every mount point
- Label the switch so the driver knows its function
Specifications
| Brand | Low Range Offroad |
|---|---|
| Part number | LRODIY-ELSR |
| Position | Rear |
| Switch type | DPDT (double pole double throw) |
| Fitment | Universal fit |
| Harness | Short harness to the differential required; 6-lead wire commonly spliced in |
Vehicle fitment
It is written for a rear Toyota Electric E Locker and is a universal fit. Confirm the rear locker and its factory harness match this wiring plan before you connect anything.
Confirm the rear locker and its factory harness match this wiring plan before you connect anything. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Keep the switch wiring separate from the factory Toyota harness. Use a short harness to the rear differential, and if splicing, 6-lead trailer wire can be joined into the factory differential harness.
What’s included
Check the package contents against your installation before starting.













