Overview
The Alloy USA Jeep Differential Cable Lock Kit, part number 450920, is a cable-operated lock kit for front lockers on lifted Jeeps. It is named for 3-6in lifted 1984-1991 Jeep XJ and 1987-1995 Jeep YJ models.
A cable lock gives the driver manual control over engaging and disengaging a front locker from inside the vehicle. The kit uses positive actuation rather than vacuum, so it does not depend on engine vacuum. In 2WD low range it gives full cab control for tight turns off-road.
Key features
- Positive manual engagement and disengagement
- Not vacuum dependent
- Designed for vehicles with a 3-6in lift
- Intended for use with front lockers
- Allows disengagement of a front locker from inside the vehicle
Cable lockers on a lifted Jeep
A cable locker trades a little setup time for direct control, and the cable run is where most problems start. Bends that are too tight, a kinked sheath or debris in the housing all make the handle stiff. Route the cable with gentle curves, keep it clear of exhaust heat and moving suspension parts, and secure the sheath at each end so it does not shift as the axle cycles through its travel.
Once installed, operate the locker several times while stationary and again on a short test run. Smooth engagement and a clean release are the signs of a good install. Periodically inspect the cable for fraying and the sheath for cracks, and clean and lubricate the cable ends when grit collects. Stiff or sticky operation usually means the run needs attention before it gets worse.
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 450920 |
| UPC | 804314226442 |
| Lift height | 3-6 in |
| Actuation | Positive, not vacuum dependent |
| Vehicle application | Jeep XJ and YJ |
Vehicle fitment
It is for 3-6in lifted 1984-1991 Jeep XJ and 1987-1995 Jeep YJ models.
Confirm fit for your vehicle’s year, model and trim before ordering, especially if it is a TJ, LJ, JK or a Cherokee from after 1991.
Installation notes
Installing it means routing the cable from the cab to the locker, so measure the run against your own lift and locker before starting.
What’s included
Check the package contents against your installation before starting.
Not included: the front locker itself, which the kit is meant to work with.
































