Overview
The Bushwacker Trail Armor rear corner guard, part number 14004, is a black plastic protector for the rear corners of a Jeep Wrangler body. It handles brush, trail debris and tight rock sections, and it is a direct fit that installs without drilling.
The guard is made from Dura-Flex 2000 TPO, a proprietary automotive protective material. The plastic is ruggedized for extra durability and flexibility, and it does not rust like steel. It is 100% UV protected to prevent chalking. The guard is made in the USA to tight tolerances for a factory-like fit.
Key features
- Diamond textured black plastic finish
- Dura-Flex 2000 TPO automotive protective plastic
- 100% UV resistant to prevent chalking
- Does not rust, unlike steel
- Designed for a factory-like fit with tight tolerances
- Installs with automotive-grade 3M adhesive, no drilling needed
- Made in the USA and backed by Bushwacker’s Limited Lifetime Warranty
Adhesive mounting tips
Adhesive-mounted body protectors depend on a clean, dry bond surface. Wash the area with a mild cleaner, remove wax and road film, and let it dry fully before setting the guard. Oily or dusty surfaces can cause the bond to fail early, and a loose edge can catch brush and peel further. Test-fit the guard without adhesive first so you know the alignment before committing.
Temperature matters too. Adhesive bonds set best in moderate conditions, so avoid mounting in direct sun or cold weather unless the adhesive’s own directions allow it. After installation, inspect the edges every few weeks and press down any corner that lifts. Trail mud and washing can wear the edge over time, so clean it regularly and check for early signs of lifting, cracking or fading.
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 14004 |
| UPC | 90689107336 |
| Product type | Rear corner guard, short corner type |
| Material | Black plastic, Dura-Flex 2000 TPO |
| Finish | Diamond textured black |
| Fitment type | Direct fit |
| Installation type | No cutting or drilling required |
Vehicle fitment
The guard is made for the Jeep Wrangler. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mounting relies on automotive-grade 3M adhesive rather than fasteners, so the guard is set in place without drilling. Because the bond depends on the adhesive, the mounting surface matters. The catalog gives no cure times, so follow the adhesive’s own directions.
What’s included
The item is the rear corner guard, part number 14004. Not included: no other Trail Armor pieces are part of this item.












