Overview
The Bushwacker Pocket Style Rocker Panels, part number 14008, are black Dura-Flex plastic rocker guards designed to match pocket style fender flares. They cover the rocker area below the doors, where road debris, stones and brush contact are most common on a Jeep Wrangler. The panels mount without cutting or drilling.
The panel is made from Dura-Flex 2000 TPO, a proprietary automotive protective material. The plastic is ruggedized for extra durability and flexibility and does not rust like steel. It is 100% UV protected to prevent chalking and made in the USA to tight tolerances for a factory-like fit.
Key features
- Designed to match pocket style fender flares
- Dura-Flex 2000 TPO plastic with a diamond textured surface
- 100% UV protected to prevent chalking
- Non-rusting plastic rather than steel
- Mounts without drilling, using automotive-grade 3M adhesive
- Made in the USA with a tight, factory-like fit
- Covered by Bushwacker’s Limited Lifetime Warranty
Rocker protection on the trail
Rocker panels take a lot of contact on a Wrangler because they sit low, between the wheels and the doors. Rocks, stumps and ruts strike this area first, and trail debris can wedge into the gap between the panel and the body. Pocket style flares and rocker guards are often chosen together so the lower body lines up, and the panel should sit flush with the flare edge for a clean look and to avoid snagging.
Plastic panels do not corrode, but they can crack under a hard impact or lift at the edges if the adhesive bond is weak. Inspect the panel after trail runs, check the bond along the top and bottom edges, and press down any lifting area promptly. Keep the surface clean of mud and grit, since abrasive buildup can dull the diamond texture over time. Rocker repairs are easier when the panel is still attached and undamaged.
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 14008 |
| UPC | 90689107602 |
| Type | Plastic guard, rocker panel |
| Material | Dura-Flex 2000 TPO plastic |
| Finish | Black plastic, diamond textured |
| Fitment type | Direct fit |
| Installation type | No cutting or drilling required |
Vehicle fitment
The panels are designed for the Jeep Wrangler. Check the year, generation and body style against your Wrangler before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mounting uses automotive-grade 3M adhesive rather than fasteners, so the panel is set in place instead of bolted on. Follow the adhesive’s own directions for surface preparation and cure time.
What’s included
The item is the rocker panel itself. Not included: the pocket style fender flares the panels are designed to match are not part of this item.














