Overview
The Body Armor TC-19335 is a front winch bumper for the Toyota Tacoma in a textured black powder coat. Body Armor says its two-piece design keeps the weight down so the bumper does not nose-dive the front of the truck.
A 3/16 inch subframe and winch plate bolts directly to the front frame rails, and the winch plate is designed for a winch up to 9500 pounds, with a side control box design working best. There is room for a small air compressor. The 11 gauge steel outer shell mounts at the shackle points with eight bolts, so the whole installation is bolt-on.
Key features
- Two-piece design to keep weight down
- 3/16 inch subframe and winch plate attached directly to the front frame rails
- Winch plate for a winch up to 9500 pounds; side control box design works best
- Room to mount a small air compressor
- 11 gauge outer shell mounted with eight bolts at the shackle points
- Light pockets for aftermarket lights or the OEM fog lights, with two more light mounting points on top
- High clearance corners and a low center section with skid plate type protection
- Textured black powder coat
Frame, winch and weight balance
A winch bumper moves weight to the front of the truck, which changes steering feel, braking and how the front suspension works on uneven ground. A two-piece design keeps the upper shell lighter than a single solid piece, which helps limit nose-heavy handling. The subframe carries the winch load, so the frame rails and their bolts take the strain during a pull.
Before adding a winch, think about cable length, fairlead position and the battery and wiring run to the front. A side control box keeps the controls near the driver and away from the air compressor. Check the bumper bolts and subframe bolts after each heavy pull and every few trail trips.
- Check frame bolts after heavy pulls
- Route winch cable away from lights
- Keep air compressor mounts clear of heat
Specifications
| Brand | Body Armor |
|---|---|
| Part number | TC-19335 |
| UPC | 859909002413 |
| Type | Front winch bumper |
| Vehicle named | Toyota Tacoma |
| Design | Two piece |
| Subframe and winch plate | 3/16 inch |
| Outer shell | 11 gauge steel |
| Maximum winch | 9500 pounds |
| Finish | Textured black powder coat |
| Mounting | Eight bolts at the shackle points; bolt-on |
| D-ring mount | Included |
Vehicle fitment
The bumper is built for the Toyota Tacoma.
Tacoma generations vary, so match the year, model and trim of your truck before you buy.
Installation notes
The shell mounts at the shackle points with eight bolts, so installation is all bolt-on. The winch plate suits a winch up to 9500 pounds, and a side control box winch works best.
What’s included
- Front winch bumper with two-piece construction
- Subframe and winch plate
- D-ring mount
- Light pockets
Not included: a winch, lights and any air compressor.









