Overview
The Body Armor JK-6125-2 is a steel roof rack base for 2-door Jeep models, supplied with side tubes and a cross tube. It pairs with part JK-6124-1, which carries the uprights and hardware.
The front crossbar has four welded light tabs for auxiliary lights, and the rear bar has two tabs for rear facing lights. Access holes under the tabs and internal holes in the elbow joints let wires run inside the tubes. The finish is a dual process textured black powder coat.
The front uprights attach to the A pillars with the four existing bolts on each side. The rear uprights can mount on the frame rails for a no-drill installation. Mounting near the taillights on the body requires four drilled holes, and frame mounting requires modifying the factory rear bumper.
The 5125 adapters allow Yakima towers and crossbars for bikes, kayaks or a roof top tent.
Key features
- Side and cross tubes included
- Front crossbar with four welded light tabs
- Rear bar with two light tabs
- Internal wire routing through the elbow joints
- Rear uprights mount without drilling
- Dual process textured black powder coat
Two-door roof rack planning
A two-door roof rack base has a shorter wheelbase and a different body profile, so the load and the mounting points feel different than on a four-door. Plan the crossbar position around the rear door and the spare tire area if the vehicle has one, so the load stays clear of the swing and the opening. Measure before drilling anything.
The front uprights bolt to the A pillars, which carry the windshield frame, so keep the bolts snug and check them periodically. Frame mounting changes the rear bumper and is hard to reverse, so decide on it early. For the lights and wiring, route the cable through the tube passages and secure it with clips.
- Measure before drilling
- Check A-pillar bolts periodically
- Secure wiring with clips
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | JK-6125-2 |
| UPC | 859909002901 |
| Material | Steel tube |
| Finish | Dual process textured black powder coat |
| Light tabs | Front crossbar four welded, rear bar two |
| Drilling | Not required, per the spec listing |
| Companion part | JK-6124-1 |
| Models | 2-door |
Vehicle fitment
It is designed for 2-door models only. Match your year, model and trim to the covered vehicles before buying.
The JK-6124-2 listing names both 2 and 4-door models, while this part names 2-door models only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The front uprights use the four existing bolts on each side at the A pillars. Frame mounting requires modifying the factory rear bumper, and the body-mount option requires drilling four holes near the taillights. Drilling and bumper changes are permanent, so check every hole position before starting.
What’s included
Side and cross tubes are included.
Not included: The uprights and hardware listed with JK-6124-1, auxiliary lights, and accessories.









