Overview
The Bilstein 5100 Series Shock Absorber, part number 24-186766, is a rear monotube shock absorber with a 46mm smooth non-coilover body and 14mm eye mounts at both ends. It suits lifted trucks, Jeeps and prerunners in general terms, so confirm the fit for your own vehicle before ordering.
Bilstein’s single tube, high gas pressure design aims for consistent, fade-free performance and long life. The shock has self-adjusting deflecting disc valving, a high-flow piston, separate rebound and compression tuning and a larger working piston area. Control on large diameter tires is also a design goal.
Collapsed length is 15.79 in, extended length is 25 in and travel length is 9.21 in. The shock is positioned for specific lift kits that keep the factory mounting layout, with a lift height of w/0 – 1 in. Lift.
Key features
- Monotube design with gas pressure construction
- Valving that self-adjusts through a deflecting disc
- High-flow piston that Bilstein says eases harshness
- Separate rebound and compression tuning
- Expanded working piston area for damping control
- Positioned for particular manufacturer lift kits with factory mounting layout
- Boot included
Choosing a lift height
Lift height decides how much of the shock’s travel is used when the truck is loaded and on the trail. A shock that is too long will not reach its full range when the suspension compresses, and one that is too short can run out of travel and bottom out. The collapsed and extended lengths on this shock are the numbers to compare with your current suspension height, not just the lift label.
Rear shocks often wear in step with the bushings and bump stops they work against. Check the eye mounts for cracks and elongated holes, and look at the bump stops for compression or splitting. Shocks that run in pairs keep the rear end level, so a matched pair is usually the better choice when one side fails.
- Compare collapsed and extended length to your ride height
- Inspect bump stops for compression or splitting
- Check eye mounts for cracks or elongation
- Replace rear shocks in pairs when one side fails
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-186766 |
| UPC | 657860562911 |
| Series | 5100 Series |
| Position | Rear |
| Charge | Gas charged |
| Internal design | Mono tube |
| Body design | 46mm ID smooth body (non-coilover) |
| Collapsed length | 15.79 in |
| Extended length | 25 in |
| Travel length | 9.21 in |
| Lower mount | Eye 14mm |
| Upper mount | Eye 14mm |
| Shaft diameter | 14mm |
| Finish | Zinc Plated |
| Lift height | w/0 – 1 in. Lift |
| Reservoir | No |
| Boot included | Yes |
Vehicle fitment
This rear shock is a general application for lifted trucks, Jeeps and prerunners. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the shock is positioned for particular lift kits, confirm that your kit keeps the factory mounting layout before fitting it. With a listed lift height of w/0 – 1 in. Lift, compare the collapsed and extended lengths against your suspension geometry.
What’s included
One shock absorber with a boot.
Not included: Mounting hardware is not included with this shock.









