Overview
The Bestop PowerBoard Retractable Electric Running Board 75151-15 is a black retractable step for two-door 2007–2018 Jeep Wrangler JK models. Electric motors extend the boards when a door opens and retract them when the doors close, so the steps stay tucked under the body while driving.
The PowerBoard uses a torsion bar design, which starts retracting the non-motorized linkage first. The step drops about 4 inch down and 2 inch out, forming a stair-step that is easier to climb than a flat board. The boards are full length and work on the front and rear doors on both sides.
The kit is a dedicated two-door unit with patented, high strength, die-cast aluminum linkage. Its motor and linkages are OEM validated, and it is built for two-door 2007–2018 Jeep Wrangler JK models rather than as a universal running board.
Key features
- New torsion bar design begins retraction of the non-motorized linkage first
- Drops about 4 inch down and 2 inch out for a stair-step
- Patented high strength, die-cast aluminum linkage
- Built-in anti-pinch safety feature
- OEM validated quality motor and linkages
- Integrated LED light kit with a 6.25 inch wide aluminum board and powdercoat surface
- 600 pound load capacity per side
Torsion bar design explained
A torsion bar gives a running board its controlled motion. Instead of relying only on the motor to lift the step, the bar stores and releases spring force through the linkage, which can reduce strain on the motor and make the travel feel more even. Understanding this helps when you inspect the mechanism, because a bent or seized bar can change how the step moves.
Two-door Jeeps have a shorter door opening, so the step’s path and the body clearance deserve attention. Watch the board cycle while the Jeep is parked on flat ground, and look for contact with the fender, the rocker or the tire at full extension. Adjust the mounting before trusting the step on a trail.
Regular checks keep the mechanism working. Clean the linkage, look for cracks around the bar mounts, and listen for grinding that may point to grit in the joints. Any change in motion or sound is a reason to stop and inspect before using the boards again.
- Watch full travel for body or tire contact
- Inspect bar mounts for cracks
- Stop and inspect at any change in motion or sound
Specifications
| Brand | Bestop |
|---|---|
| Part number | 75151-15 |
| UPC | 77848130350 |
| Finish | Black |
| Length | Cab |
| Fitment type | Direct fit |
| Board width | 6.25 inch |
| Drop | About 4 inch down |
| Outward offset | 2 inch |
| Load capacity | 600 pounds per side |
| Warranty | 3 year/36,000 mile |
Vehicle fitment
It fits two-door 2007–2018 Jeep Wrangler (JK) models with 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims. Verify your year, model and trim fit before you order.
Four-door Wrangler Unlimited models use the 75152-15 kit instead. Wrangler TJ, LJ and JL models are not covered by this list.
Installation notes
Work through the mounting steps in order and check each fastener before use. Disconnect the battery before connecting the controller or the motor wiring.
What’s included
Two full length boards, an OEM quality motor, a controller, hardware, a wiring harness with weatherproof connectors and an LED light kit.




















