Overview
The Bestop PowerBoard NX for 4-door Jeeps, part number 75652-15, is a retractable electric running board for the 2007–2018 Jeep Wrangler Unlimited (JK). It pairs the classic PowerBoard step with a wireless control system, so the install skips the factory door wiring altogether.
The steps retract beneath the body while the doors are shut and drop to a foot-friendly height as each door swings open. Both front and rear doors, on the driver and passenger sides, trigger the boards. Each side handles up to 600lb, and the unit has been climate and salt spray tested. A 3 year/36,000 mile limited warranty applies.
Key features
- Wireless signaling means the install never reaches the factory harness or any interior trim piece.
- Steps lower on their own when a door opens and lift back when it closes.
- The 6.25 inch step is extruded aluminum with a textured, non-slip powder coat.
- Die-cast aluminum linkage and sturdy arms let the step descend up to six inches.
- An integrated LED light kit and corrosion-coated fasteners come standard.
- A pinch-proof, weatherproof motor helps keep the steps safe to use.
- The NX add-ons, 4 door sensors and a receiver unit, tie the wireless system together.
- Rated for a 600lb load per side and tested against salt spray and climate extremes.
Sizing the step to your use
A 6.25 inch step gives a wide, stable surface, but the width also means the board sits closer to the tires and body when it is retracted. Think about what the step will carry and how the Jeep is used. A board that is used to climb onto a roof rack or cargo area should be checked for flex and wear more often than one used only for entry.
Trail use changes the picture. Rock rails, larger tires and lift components all alter the position of the step and the space around it. Before mounting, confirm that the step still clears the body at full extension, and plan a short test cycle on level ground so any contact shows up before the first outing.
Keeping the step clean makes a real difference. Mud and grit left on the arms can work into the pivots and slow the motion. A quick wash and a check of the fasteners after each outing helps the board travel smoothly and keeps the connectors free of debris.
- Check flex and wear if used for loading
- Test the full travel on level ground after mounting
- Wash arms and pivots after muddy outings
Specifications
| Brand | Bestop |
|---|---|
| Part number | 75652-15 |
| UPC | 77848130336 |
| Model | PowerBoard NX, wireless door control version |
| Door configuration | 4-door |
| Finish | Black |
| Length | Cab |
| Fitment type | Direct Fit |
| Step width | 6.25 inch |
| Step drop | Up to six inches |
| Load capacity | 600lb per side |
| Warranty | 3 year/36,000 mile limited |
Vehicle fitment
The manufacturer list places this 4-door kit on the 2007–2018 Jeep Wrangler (JK) Unlimited, covering the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims.
Two-door Wrangler bodies use the separate 2-door kit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Rubicon rock rails need to come off before the boards go on. Wireless control means the harness is not spliced into the factory system, which keeps the install simpler and avoids conflicts with aftermarket wiring such as security systems and remote starts. Keep clear of the stepping area while the boards are moving.
What’s included
The complete kit includes two steps, a wiring harness and controller, weatherproof motors, an LED light kit and hardware. The wireless NX components add 4 door sensors and a receiver unit.

















