Overview
The Bestop Highrock 4×4 End Caps Kit, part number 44941-01, is a set of two black powder coated steel end caps for the Bestop Modular Rear Bumper 44940-01 on the 2007–2018 Jeep Wrangler JK.
The end caps attach to pre-drilled holes on the modular bumper and extend its center section for a wider profile. Each cap is made of 1/8″ thick steel with a polymer top cap. The passenger-side end cap can be modified to mount the optional Tire Carrier Assembly, and the caps can be removed for more tire clearance on tough trails or rocks.
Key features
- Set of 2 end caps
- 1/8″ thick steel with polymer top cap
- Extends the center section of the modular rear bumper for a wider profile
- Attaches to pre-drilled holes on bumper 44940-01
- Passenger-side end cap can be modified for the optional Tire Carrier Assembly
- Removable for more tire clearance
- E-coat base layer with matte-black powder coat top finish
Caring for the caps
End caps see more road spray, mud and rock contact than most bumper parts, so their finish needs regular attention. A matte-black powder coat resists everyday wear, but a chip that exposes bare steel can start to rust. Wash the caps after muddy trips and look closely at the edges where the polymer top cap meets the steel.
Check the mounting hardware on each cap after the first few trail runs and again at regular service intervals. Loose bolts can rattle or shift the caps, so tighten them evenly. If a cap is removed for tire clearance, store the hardware with it so nothing is lost.
- Touch up chips in the powder coat
- Wash mud off after trail use
- Re-check cap bolts periodically
Specifications
| Brand | Bestop |
|---|---|
| Part number | 44941-01 |
| UPC | 77848131739 |
| Product type | Rear bumper end caps |
| Quantity | Set of 2 |
| Material | Steel, 1/8″ thick, with polymer top cap |
| Finish | Electrostatically-applied E-coat base with matte-black powder coat |
| Fitment type | Direct fit |
| Works with | Bestop Modular Rear Bumper 44940-01 |
Vehicle fitment
The end caps are made for the 2007–2018 Jeep Wrangler JK, and they are designed for the Bestop Modular Rear Bumper 44940-01.
They fit only that modular bumper. Verify fit for your vehicle’s year, model and trim before buying.
Installation notes
The end caps attach to the pre-drilled holes on the modular bumper using the supplied mounting hardware, and instructions are included. Modifying the passenger-side cap for the tire carrier is optional.
What’s included
- Two end caps
- Mounting hardware
- Instructions
Not included: the modular rear bumper 44940-01 and the optional tire carrier.









