Overview
The Baer Brakes 6910957 is a left-side, 1-piece plain finish replacement brake rotor measuring 15.000 inch in diameter and 1.180 inch thick, made for select Baer Brake systems. It is a vented, directional rotor built for one side of the vehicle and should be fitted only on the left hub. It has a 6 x 5.50 inch bolt pattern and a 3.094 inch center hole, so check those two measurements against the hub you are replacing first.
Brake rotors take the friction from the pads on every stop, which makes this a wear part for a Baer system. The casting is full cast, one-piece cast iron, with a curved vane design that aids cooling and castings designed to resist distortion. The surface is plain.
Key features
- Left-side directional rotor, sold for the left side of the vehicle only
- Full cast, one-piece cast iron construction
- Plain friction surface on a vented design
- Curved vane design, described by Baer Brakes as aiding cooling
- Dynamically balanced for vibration-free running
- Sold as each
Before you buy
Brake rotors wear down as the pads clamp against their friction surface, so thickness loss, scoring, heat cracks and a pulsing pedal are common signs that a rotor has reached the end of its useful life. When a rotor is replaced, look at the pads, hub bearings and caliper slide pins at the same time, since worn parts in that area can shorten the life of a new rotor.
Directional rotors are a common source of mistakes during brake work. A rotor marked for one side should go on that side only, and the opposite rotor should be inspected for type and condition before the job is finished. Clean rust and debris from the hub face before mounting, because even small deposits can cause runout that shows up as vibration under braking.
- Measure the rotor thickness against its minimum stamped value before reusing any old rotor
- Bed in new pads gradually after installation
- Torque wheel fasteners evenly and recheck them after the first few drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6910957 |
| UPC | 844165035367 |
| Axle position | Left |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Surface type | Plain |
| Rotor type | Vented, directional |
| Outside diameter | 15.000 in |
| Nominal thickness | 1.180 in |
| Overall height | 2.177 in |
| Center hole diameter | 3.094 in (register) |
| Stud/lug hole circle diameter | 5.50 in |
| Stud/lug hole quantity | 6 |
| Drum in hat | No |
| ABS tone ring included | No |
| Grade type | Performance |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It fits select Baer Brake systems in the left-side position. Before ordering, match the rotor to your vehicle’s year, model and trim.
The 6910957 is the left-side rotor only; the right-side rotor is a separate part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the rotor is directional, mount it on the left hub only. Check the 3.094 inch center hole and the six 5.50 inch bolt holes against the hub before fitting. Brake work affects stopping performance, so have a qualified technician install and test the brakes.
What’s included
One left-side replacement rotor, sold as each.
Not included: Brake pads, calipers, hub and mounting hardware are not part of this item, and the right-side rotor is sold separately.
