Overview
The Baer Brakes 6920342 is a one-piece, right-side replacement rotor with a tall hat, a 13.000 in outside diameter and a 1.100 in nominal thickness. It is slotted, drilled and zinc-plated, and it uses four lug holes on a 108 mm bolt hole circle with a 2.781 in center register.
This rotor fits select Baer Brake systems. Its one-piece full cast body is directional, so it mounts on the right side only. The overall height of 2.232 in should be measured against the rotor being replaced before fitting.
Key features
- One-piece full cast construction
- Slotted, drilled and zinc-plated friction face
- Tall hat with a 2.781 in center hole diameter
- Vented cast iron design
- Curved vanes designed for cooling.
- Dynamically balanced for smooth running
- Directional build, right side only
Checking hub clearance
A tall hat rotor moves the friction face farther from the hub, which changes how it sits against the caliper and wheel. Before mounting, confirm the hub register is clean and that the caliper bracket has room for the taller ring. Tall hat designs are often replaced as a complete unit, so check the pad and caliper fit together.
Drilled and slotted faces are useful for airflow and debris clearing, but the holes and slot edges can crack under repeated heat cycles. Zinc plating protects the surface from light corrosion, yet scratches should be cleaned and checked. Inspect the holes and edges at regular brake service and replace the rotor if cracks reach the friction edge.
After installation, bed in the pads at moderate speed and avoid hard stops until the surface has conditioned. Re-check the wheel and hub bolts after the first few runs.
- Clean the hub register before mounting
- Check caliper bracket clearance over the taller hat
- Inspect drilled holes and slot edges for cracks
- Bed in pads gradually after fitting
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920342 |
| UPC | 844165054597 |
| Sold as | Each |
| Country of origin | USA |
| Axle | Right |
| Construction | Full cast, one piece |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Solid or vented | Vented |
| Material | Cast iron |
| Grade type | Performance |
| Outside diameter | 13.000 in |
| Nominal thickness | 1.100 in |
| Overall height | 2.232 in |
| Center hole diameter | 2.781 in |
| Stud/lug hole quantity | 4 |
| Stud/lug hole circle diameter | 108 mm |
| Drum in hat | No |
| ABS tone ring included | No |
| Emission code | 6 |
Vehicle fitment
Intended for select Baer Brake systems. Compare the four-lug 108 mm pattern, the 2.781 in center register and the 2.232 in overall height with your hub before fitting. Check your year, model and trim before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rotor is directional, so confirm the side before fitting. The tall hat places the mounting face higher than a standard hat, which is why the 2.232 in overall height should be checked against the hub. Bed in new pads after installation and test the brakes at low speed. Inspect the drilled holes and slots at regular brake service intervals.
What’s included
One right-side rotor.
Not included: Brake pads, calipers and hub hardware are separate items.
