Overview
The Baer Brakes 6910150 is a 12-inch, left-side slotted, drilled and zinc-plated replacement brake rotor for the rear SS4 system and select Baer Brake systems. It is a vented, one-piece full cast rotor with five lug holes on a 4.75-inch bolt circle, and rotors are sold individually.
The rotor is a purpose-built casting with a curved vane design that aids cooling. It is directional, made for one side of the vehicle only, and this part is the left-side version.
Key features
- Curved vane design intended for cooling
- Slotted and drilled friction surface
- Zinc-plated finish
- Dynamically balanced for vibration-free performance.
- Designed for rotor stability and resistance to distortion
- Directional rotor made for the left side of the vehicle
Before you install
Brake rotors work with the pads and caliper to slow the wheel by creating friction at the friction surface. A vented rotor has two faces joined by internal vanes, which lets air move through the disc and carry heat away during repeated stops. Slotted and drilled surfaces are often chosen for wet or hard-use driving, since the slots help clear debris and gas from between the pad and rotor, though they can wear pads faster on some setups.
Directional rotors are cast with a rotation direction in mind, so the side marking matters when the rotor is installed. Rotors are often replaced in pairs on the same axle so braking stays even from side to side. When replacing the rotor, pads, hardware, and any wheel bearing or hub seals within reach are commonly inspected at the same time. Check the new rotor’s surface for cracks, and clean any protective coating from the friction surface before fitting.
- Measure remaining rotor thickness against the minimum stamped on the old rotor
- Confirm the rotor side before tightening the hub bolts
- Re-check the lug nuts after the first few drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6910150 |
| UPC | 844165051077 |
| Axle | Left |
| Outside diameter | 12 in |
| Nominal thickness | 1.02 in |
| Overall height | 2.406 |
| Stud/lug hole quantity | 5 |
| Stud/lug hole circle diameter | 4.75 in |
| Center hole diameter | 2.78 in |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Grade type | Performance |
| Drum in hat | Yes |
| ABS tone ring included | No |
| Emission code | 6 |
| Country of origin | CN |
| Sold as | Each |
Vehicle fitment
It is made for the rear SS4 system and select Baer Brake systems. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rotor is directional and made for the left side only, so confirm the side before fitting it. The ABS tone ring is not included, so any tone ring your system uses must be handled separately.
What’s included
One left-side replacement rotor, sold individually.
Not included: ABS tone ring.












