Overview
The Baer Brakes 6920186 is a right-side, 2-piece replacement brake rotor with an 11.625 inch outside diameter and 0.705 inch nominal thickness. It has a slotted, drilled and zinc plated surface and is used in certain Baer SS4 Plus Deep Stage systems and other Baer brake systems.
The cast iron rotor uses a curved vane design that moves air to aid cooling. It is dynamically balanced for vibration-free running and is made from premium materials. Match the 12 x 7.5 inch bolt pattern and the directional brake surface against the rotor being replaced.
Key features
- Right-side rotor with a directional brake surface
- Two-piece construction with a vented cast iron rotor
- Slotted, drilled and zinc plated finish
- Curved vane design for optimum cooling
- Dynamic balanced for vibration free performance
- Rotor stability design intended to resist distortion
Before you buy
A replacement rotor is most often chosen because the original is worn, warped or damaged. The safest choice matches the original in diameter, thickness, hat style and bolt pattern. Before buying, measure the rotor you are removing and compare it with the measurements above. Measure thickness at several points, since uneven wear can make a rotor look fine while it is out of spec. A rotor that is too thin overheats and can crack, so replace it once it reaches the minimum thickness stamped on it.
Rotors are usually replaced in pairs, and the other side should match in construction and finish. Brake pads should be replaced along with the rotor so the new surface beds in against fresh friction material. Check the caliper slide pins and the hub face for rust or damage at the same time, because a clean mounting face keeps runout low.
- Measure the old rotor before ordering
- Replace pads together with the rotor
- Inspect caliper slide pins and hub face
- Confirm the directional mark before fitting
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920186 |
| UPC | 844165053415 |
| Axle | Right |
| Construction | Two piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Outside diameter | 11.625 in |
| Nominal thickness | 0.705 in |
| Bolt hole circle diameter | 7.5 in |
| Bolt hole quantity | 12 |
| Material | Cast iron |
| Grade type | Performance |
| ABS tone ring included | No |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is used in certain Baer SS4 Plus Deep Stage systems and other Baer brake systems. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These rotors are directional and sold individually, so this right-side unit belongs on the right axle only. Confirm the slot orientation against the rotor on the left side before assembly. A rotor that is mounted incorrectly will not perform as designed, so have a qualified brake technician check the hub and caliper fit.
What’s included
One right-side, two-piece replacement brake rotor.
Not included: ABS tone ring.
