Overview
The Baer Brakes 6910354 is a left-side, 2-piece replacement brake rotor measuring 11.000 inches in outside diameter and 1.020 inches thick, with ten mounting bolt holes on a 6.40-inch bolt hole circle. It is a slotted, drilled and zinc-plated vented rotor ring for certain Baer Pro Plus systems and other Baer Brake systems.
This rotor is directional and built for the left side of the vehicle only. It is sold individually, so a right-side rotor is a separate purchase. The grade is performance and the material is cast iron.
Key features
- Two-piece construction with a separate rotor ring
- Curved vane design that Baer describes as optimal for cooling
- Dynamically balanced for vibration-free running
- Slotted, drilled and zinc-plated surface finish
- Directional braking surface matched to the left side
- Castings made from premium materials, designed for rotor stability and resistance to distortion
Before you buy
Brake rotors work together with the pads, calipers and hub, so a rotor change is best treated as part of a full brake check. Before ordering, confirm the Baer system you already run, since rotor fit depends on that system’s hub and caliper setup rather than on the rotor alone. Left and right rotors are ordered separately, so count each side you plan to replace.
Slotted and drilled rotors help shed gas and water, but they can show cracks and edge wear sooner under hard use. Inspect the braking surface for heat checking, deep grooves or a raised lip at the outer edge. Measure thickness against the minimum stamped on the old rotor or listed in the service manual, and replace pads together with rotors so the new surface seats evenly.
- Check hub runout before mounting the rotor
- Clean the hub face and remove rust before fitting
- Bed in new pads after installation
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6910354 |
| UPC | 844165012139 |
| Axle side | Left |
| Construction | Two piece |
| Outside diameter | 11.000 in |
| Nominal thickness | 1.020 in |
| Mounting bolt hole circle diameter | 6.40 in |
| Mounting bolt hole quantity | 10 |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Material | Cast iron |
| Grade type | Performance |
| Emission code | 6 |
| ABS tone ring included | No |
| Sold as | Each |
| Country of origin | CN |
Vehicle fitment
No year, model or chassis code is attached to part 6910354. It is made for certain Baer Pro Plus systems and other Baer Brake systems, so fitment depends on the Baer system you already run.
Installation notes
Mount this rotor on the left hub only, because the directional surface and left-side design do not suit the right side. Brake components affect stopping, so have a qualified technician handle the install and test the brakes before driving.
What’s included
One left-side 2-piece rotor ring, sold as each.
Not included: an ABS tone ring, since this rotor ring does not include one.













