Overview
The Baer Brakes 6800503 is a 25.25 inch braided brake hose set with a 3AN female straight fitting on one end and a 10mm, 20 degree banjo end on the other. The set contains two hoses, supplied as a pair, and each hose attaches directly to the OE hard line.
Steel braiding and a Teflon liner limit hose expansion, which helps keep a consistent pedal feel. The hose is DOT approved. Confirm the fitting ends and length against your application before choosing this set.
Key features
- Stainless steel hose with a steel braided covering
- Teflon liner to limit expansion for a consistent pedal feel
- DOT approved
- Attaches directly to the OE hard line
- Two hoses supplied as a pair
- Performance grade with steel fittings
Routing and bleeding
Braided hoses form a flexible connection between a fixed hard line and a moving caliper or axle. Routing matters: keep both hoses clear of tires, springs, steering components and exhaust heat, and make sure they are not twisted when the suspension is at full travel. A hose that is twisted or touching a part can chafe and fail over time.
Tighten fitting ends in the correct order, and snug banjo bolts rather than overtightening them. Brake fluid should match the DOT grade your system requires. After installation the system must be bled, and the pedal should be checked for firmness before driving. Inspect the hoses again after the first few drives.
- Check both hoses for twist at full steering lock
- Use new crush washers on each banjo
- Bleed each caliper in the correct sequence
- Look for seepage at both fittings
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6800503 |
| UPC | 90127990681 |
| Hose length (hose 1) | 25.25 inch |
| End 1 fitting | -3 AN female straight |
| End 1 thread size | 3/8-24 inch |
| End 1 thread type | UNJF |
| End 2 fitting | 10mm banjo, 20 degree |
| Banjo bolt hex size | 10 mm |
| Fitting material | Steel |
| Hose material | Stainless steel braided |
| Liner | Teflon |
| Grade | Performance |
| DOT approved | Yes |
| Crush washers included | No |
| Bracket attached hose 1 | No |
| Bracket attached hose 2 | No |
| Emission code | 6 |
| Package type | Set of 2 hoses |
| Country of origin | USA |
Vehicle fitment
The set is matched by its fittings and length, so the 3AN female straight end, the 10mm banjo end and the 25.25 inch length must suit your application. Confirm fit for your vehicle’s year, model and trim before ordering.
Sets with other fitting sizes or lengths fall outside this set’s scope. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Banjo ends need crush washers, and this set does not supply them, so have new washers ready before fitting. Route both hoses so they clear suspension and steering travel without rubbing or kinking. After installation the brake system must be bled, which a qualified technician should handle if brake work is new to you.
What’s included
The set contains two braided hoses with the fittings and length shown in the specifications.
Not included: Crush washers for the banjo ends. Brake fluid and bleeding equipment are not part of this set.













