Overview
The ARB RD174 is a rear Dana 70/80 air locking differential with 37 splines and 4.56 up gearing. The selectable air locker turns an open differential into a full spool, so power reaches both wheels when traction is uneven. No vehicles are named, so the axle type and spline count are the matching details.
Spline count is the key check for this unit, since a 37 spline locker will not match axles with other spline counts. Confirm the housing is a Dana 70 or Dana 80 before ordering the matching part.
Key features
- Air activated selectable locker
- Full spool operation
- Built for 37 spline axles
- Listed gearing: 4.56 up
- Fits Dana 70 or Dana 80 axles
- Rear axle location
Gearing and rear traction
A rear selectable locker suits situations where a single wheel loses grip, such as a steep rocky climb or a slick off-camber section. Air engagement changes the open rear axle into a full spool, so both rear wheels turn at the same speed and deliver drive. Because the lock works at the axle rather than at one wheel, it helps the whole rear end instead of only the wheel that spins.
The 4.56 up gearing is a higher ratio, which changes how the drivetrain responds at low and high speed. Tire size and gearing should be considered together, since larger tires move the effective ratio. After a rear axle job, recheck the axle cover bolts and inspect the seal for seepage after deep water crossings.
- Disengage the lock on pavement and in tight turns
- Recheck the axle cover bolts after the first trail runs
- Inspect the rear seals after deep water
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD174 |
| UPC | 9332018027948 |
| Differential type | Selectable air locker |
| Axle manufacturer | Dana |
| Axle type | Dana 70 or Dana 80 |
| Axle spline count | 37 splines |
| Gear ratio | 4.56 up |
| Axle location | Rear |
Vehicle fitment
The RD174 is matched to the axle housing, which should be a Dana 70 or Dana 80, along with 37 spline shafts and 4.56 up gearing. Before ordering, compare your vehicle’s year, model and trim with the fitment you need.
Front axles and other spline counts are not covered by the stated specifications. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Start with the air supply: the compressor and its plumbing must be ready before the locker can be tested. A 37 spline set in a 70 or 80 housing is a job for an axle shop experienced with selectable lockers.
What’s included
Included: the RD174 air locking differential.
Not included: An ARB onboard air compressor, which is needed to activate the locker.









