Overview
The ARB CS046RA is a leaf spring from ARB 4×4 Accessories, part number CS046RA, and a direct fit for the 1998–2004 Toyota Tacoma, including the Base, Limited, Pre Runner, S-Runner and SR5 models. Its two-stage leaf pack carries the truck unladen on the primary leaves and adds the secondary stage when the load goes up.
The leaves are draw tapered and diamond cut to spread the load over a larger area. They carry a graphite coating for lower friction, and the tension side of each leaf is shot peened. Each spring is scragged and load tested, which keeps the set and the rating consistent.
The Tacoma’s first generation spans this range, so confirm the year and trim against the models named before ordering. Because it is a rear spring, check the axle type and spring hangers on the truck before fitting.
The two-stage design and the military wrapped eye matter most for fit and ride. Matching the spring to the 1998–2004 Tacoma years and trims named here confirms the fit before installation.
Key features
- Two-stage pack for a comfortable unladen ride and extra support under load.
- Draw tapered leaves carry the load progressively along the spring.
- Diamond cut leaf ends lower the stress that builds at the tips.
- Scragged so the spring keeps a set and resists sagging.
- Load tested against its specification.
- Graphite coating between the leaves.
- Regreasable nylon anti-friction pads at the leaf tips.
- Military wrap on the spring eye for added safety.
Rear spring care
The rear springs on a Tacoma carry the bed load and the cab weight, so they see steady wear from ordinary use. Leaves rub at the nylon pads, and shackles pivot each time the axle moves. Keeping those contact points lubricated and clean slows wear and keeps the spring from squeaking on rough roads.
Inspect the spring after rough trail runs or heavy loads. Look for cracked leaves, leaves that have moved off the center bolt, and sag at one end. Check the eye bushing and the military wrap for damage too. If the other side is also aged, replacing both springs keeps the rear ride even.
- Grease the pads and shackle pivots
- Inspect the wrap and eye after trail use
- Replace springs in pairs when both sides are worn
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | CS046RA |
| UPC | 700003747871 |
| Type | Leaf spring |
| Leaf pack | Two-stage |
| Leaf ends | Draw tapered, diamond cut |
Vehicle fitment
It is a direct fit for the 1998–2004 Toyota Tacoma in the Base, Limited, Pre Runner, S-Runner and SR5 models.
Tacoma years outside 1998–2004, including the 2005 and later generation, are not on the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One leaf spring. Check the package contents against your installation before starting.





