Overview
The ARB CS031R is a heavy-load leaf spring from ARB 4×4 Accessories, part number CS031R. It is a direct fit for the 1986–1994 Nissan D21, including the Base, E, SE and XE models. The two-stage pack carries the vehicle unladen and brings in the secondary leaves when the load goes up.
The leaves are draw tapered and diamond cut, graphite coated and shot peened on the tension side. Regreasable nylon pads sit at the leaf tips, and each spring is scragged and load tested so its set holds under heavy use.
The D21 is a compact pickup, so a heavy-load rating gives the truck more capacity than a lighter spring would. Fit covers only the 1986–1994 years and the four trims named, which makes the match precise for this application.
The CS031R is a heavy-load spring for a Nissan D21, so its rating is the figure that matters most when comparing it with other springs. The two-stage pack, diamond cut leaves and graphite coating all support that rating, and the shot peened tension side reduces stress across the leaves when the load is at its highest.
Because the D21 is a smaller pickup, the spring’s rating should be read against the payload of the truck rather than against the heavy-duty figures used for larger vehicles.
Key features
- Heavy-load rating for more weight capacity.
- Two-stage pack for comfort unladen and support under load.
- Draw tapered leaves spread the load along the spring.
- Diamond cut leaf ends reduce end stress.
- Fully scragged and load tested.
- Graphite coating between the leaves.
- Shot peened tension side of each leaf.
Payload and rating
The D21 is a small pickup, so payload is the number that decides whether a spring is right. Add up the weight of the bed contents, tools, fuel and passengers, then compare the total with the rating on the spring. A truck that often runs near its limit will show sag and bottoming sooner than one with capacity to spare, so the spring should match the truck’s real use.
Springs are only one part of the rear suspension. Check the bump stops, shock absorbers and mounting hardware while the spring is out of the truck. Worn shocks let the spring bounce and hide its true ride, and worn bump stops can let the axle hit the frame on hard hits. Replacing these together keeps the rear end controlled.
- Weigh a typical load before choosing a rating
- Inspect bump stops during installation
- Recheck U-bolt torque after the first drive
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | CS031R |
| UPC | 9332018022912 |
| Load rating | Heavy load |
| Leaf pack | Two-stage |
| Leaf ends | Draw tapered, diamond cut |
Vehicle fitment
It is a direct fit for the 1986–1994 Nissan D21 in the Base, E, SE and XE models.
Other Nissan trucks and D21 years outside 1986–1994 are not on the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One leaf spring. Check the package contents against your installation before starting.




