Overview
The AEM 21-8303DP is a polished aluminum cold air intake for the 2002–2003 Jeep Liberty (KJ), available for Limited, Renegade and Sport trims. It uses a DryFlow synthetic filter in an open housing, and the inlet tube is included.
The design is intended to maximize power and can gain up to 13.3 horsepower. It meets CARB and Federal emissions requirements under CARB E.O. number D-670. The AEM1-4001 prefilter is sold separately and is not part of the kit.
Key features
- Polished aluminum finish
- DryFlow synthetic filter that never needs oiling
- Open filter housing for cold air intake use
- Up to 13.3 horsepower gain
- Meets CARB and Federal emissions
- Inlet tube included
Polished finish and upkeep
Polished aluminum intakes look sharp when new, but the finish shows fingerprints, road grime and water spots more readily than a powder coat. Clean it with mild soap and a soft cloth, and avoid abrasive pads that can scratch the surface. Rinsing after off-road trips keeps mud from drying onto the tubing, where it becomes harder to remove.
The finish is cosmetic and does not change how the filter works. Focus your service on the dry synthetic element and the inlet tube seals. Check the clamps and the open housing for loose hardware after rough driving, and tighten fasteners by hand before using a tool to avoid cross-threading.
- Clean with mild soap and a soft cloth
- Avoid abrasive pads on polished surfaces
- Check clamps and hardware after rough trips
Specifications
| Brand | AEM |
|---|---|
| Part number | 21-8303DP |
| UPC | 840879014377 |
| Finish | Polished aluminum |
| Intake type | Cold air |
| Filter housing type | Open |
| Filter type | Dry, DryFlow synthetic |
| Inlet tube | Included |
| Power gain | Up to 13.3 horsepower |
| Emissions | Meets CARB and Federal; CARB E.O. # D-670 |
| Prefilter | AEM1-4001, sold separately |
| Fitment type | Direct fit |
Vehicle fitment
The intake fits the 2002–2003 Jeep Liberty (KJ) in Limited, Renegade and Sport trims.
Other Liberty years and trims are not covered. Verify your year, model and trim before ordering.
Installation notes
The AEM1-4001 prefilter is sold separately, so plan for it if you want one. The DryFlow filter is synthetic and does not need oil, so do not add oil to it during service.
What’s included
The inlet tube is included, along with the complete hardware, heat shield and brackets AEM describes for the kit.
Not included: the AEM1-4001 prefilter, sold separately.









