Overview
The Addictive Desert Designs Rock Fighter rear bumper with sensor cutouts, part ADSR23012NA01NA, is a powder coated steel rear bumper for the 2021–2026 Ford Bronco. It has a more aggressive styling than the factory plastic rear bumper.
The bumper retains the OEM tire mount and backup camera. An included relocation bracket moves the mounting point further up so that a 37-inch spare tire can be mounted. The factory hitch and license plate light are also kept, so the bumper works with the existing rear equipment.
Two reinforced clevis mounts for 3/4-inch D-rings give the bumper recovery points. The bumper also includes sensor cutouts for the factory backup sensors.
Key features
- Relocation bracket included, moves the spare tire mount further up for a 37-inch spare
- Retains the OEM tire mount and backup camera
- Retains the factory hitch and license plate light
- Two reinforced clevis mounts for 3/4-inch D-rings
- Sensor cutouts for the factory backup sensors
- Powder coated finish
Spare tire and recovery setup
A rear bumper carries more than the spare. It is the anchor point for recovery straps and shackles, and it takes the load of a tire mounted high behind the truck. Before setting up the spare, check that the mount and bracket hardware are tight and that the spare clears the tailgate and any rear accessories when it swings.
Because the rear end is a common place for recovery pulls, use shackles that match the clevis size and rating needed for the pull. Inspect the D-ring mounts and bracket welds after hard recovery work, and replace any shackle that shows wear.
- Confirm the spare tire clears the tailgate before driving
- Use shackles sized to the clevis mounts
- Recheck bracket bolts after the first off-road trips
- Keep backup sensors clean and free of mud
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | ADSR23012NA01NA |
| Position | Rear |
| Material | Steel |
| Finish | Powder coat |
| D-ring mounts | Included, two reinforced clevis mounts for 3/4-inch D-rings |
| Spare tire | Relocation bracket supports a 37-inch spare |
| Receiver hitch | Not included, factory hitch retained |
| Tire carrier | Not included |
| Installation type | Direct fit |
Vehicle fitment
It is a direct fit for the 2021–2026 Ford Bronco.
It fits 2021–2026 Ford Bronco models. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The included relocation bracket is what allows a 37-inch spare to mount, so fit it when you install the bumper. The OEM tire mount and backup camera are kept in place.
What’s included
The powder coated steel rear bumper, the relocation bracket and the two reinforced clevis mounts.
Not included: A spare tire, a tire carrier, and D-ring shackles.




















