Overview
The Addictive Desert Designs Bronco Stealth Fighter Front Bumper, part number F230142210103, is a low-profile powder coated steel front bumper for the 2021–2026 Ford Bronco. Its bold front styling is paired with a design focused on off-road performance and clearance.
At the center of the bumper are inset mounting points for up to a 30-inch radius light bar, or for 8 cube lights. Toward the ends of the bumper are two more inset mounting points, and each takes a cube light. The OEM parking sensors are kept, and plugs are included for models without sensors.
The bottom panel has louvers that allow airflow to the intercooler. The 3/16-inch aluminum skid plate is an optional upgrade that replaces the factory plastic skid plate, and the factory skid plate can be kept if you prefer it.
Two reinforced clevis mounts take 3/4-inch D-rings for recovery when the truck is stuck in mud, sand or snow. An ADD adaptive cruise control relocation bracket is available, and the bumper is fully bolt-on and Made in America.
Key features
- Low-profile design with bold front styling
- Inset mounts for a 30-inch radius light bar or 8 cube lights in the center
- Two inset cube light mounts toward the ends
- OEM parking sensors retained, with plugs for models without sensors
- Louvered bottom panel for intercooler airflow
- Optional 3/16-inch aluminum skid plate
- Two reinforced clevis mounts for 3/4-inch D-rings
- Adaptive cruise control relocation bracket available
Wiring and light placement
Light bars and cube lights on a front bumper need a clean wiring route from the battery or fuse block to the switch. Run the harness along existing factory channels, keep it clear of hot exhaust parts and moving suspension components, and secure it with loom and clips. A relay with a fuse close to the power source helps protect the truck if a wire chafes.
Mount lights so they clear the parking sensor area and do not block the sensors. Aim them low enough to light the trail without glare on oncoming traffic. Because the center mount can take either a light bar or cube lights, plan the layout before drilling anything, and test every light before final tightening.
- Check connectors after the first few trail runs
- Keep spare fuses rated for the circuit
- Re-torque light brackets after rough terrain
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Product type | Front bumper |
| Material | Steel |
| Finish | Powder coat |
| Width | Full |
| Light mounts | Included |
| Winch mount | Not compatible |
| Hoop | Not included |
| Stinger | Not included |
| D-ring mount | Included: clevis mounts for 3/4-inch D-rings |
| Origin | Made in America |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2021–2026 Ford Bronco.
Confirm your vehicle’s year, model and trim before ordering, since this bumper is designed for the 2021–2026 Ford Bronco.
Installation notes
The bumper bolts on. Keep the factory plastic skid plate or fit the optional 3/16-inch aluminum skid plate, which is a separate choice.
What’s included
The bumper is described with its light mounts, its clevis mounts and the provision for OEM parking sensors, with plugs for models without sensors.
Not included: The optional aluminum skid plate, the adaptive cruise control relocation bracket and the lights themselves are not included.

















