Overview
The Warrior 920APC is a pair of black diamond plate aluminum rear corners with cutout holes for 4-door 2007-2016 Jeep Wrangler JK models. The manufacturer part number is 920APC, listed in Warrior as W/I920APC.
The corners are 1/8 inch thick and add structural support to the corner area. They have precut holes for the gas tank and tail light openings. The finish is black powder coat over aluminum, and they are sold in pairs.
This is a short corner with cutout holes, and the black diamond plate pattern defines its look. The material is aluminum with a black powder coat finish, so the corners are coated rather than bare metal.
Key features
- Rear corners in black diamond plate aluminum
- Cutout holes for the gas tank and tail light openings
- Material thickness of 1/8 inch.
- Black powder coat finish
- For 4-door models
- Supplied in a pair
- Cutting or drilling required for installation
Fitting and finish care
Diamond plate corners add protection to the rear quarter area, and the powder coat finish helps the surface resist everyday wear. Before fitting, remove the old corner or trim and clean the mounting area. Check the fit by setting the corner in place and marking the mounting points before drilling.
Powder coat can chip where edges are drilled or where stones strike the surface. Touch up exposed metal with a matching paint or primer to slow corrosion, and wash the corners regularly to remove road salt and grit. Inspect fasteners and rubber isolators after the first trips and tighten them as needed.
- Deburr drilled edges before fastening
- Touch up chips in the powder coat promptly
- Rinse off road salt and grit regularly
- Recheck fasteners after the first few trips
Specifications
| Brand | Warrior |
|---|---|
| Part number | 920APC |
| UPC | 63414692005 |
| Product type | Rear corners (corner guards) |
| Alternate part number | W/I920APC |
| Application | 4-door models |
| Material | Aluminum, diamond plate |
| Material thickness | 1/8 inch |
| Finish | Black powder coat |
| Corner type | Short |
| Holes | With cutout holes |
| Quantity | One pair |
| Fit type | Direct fit |
| Installation type | Cutting or drilling required |
Vehicle fitment
The 920APC fits the Wrangler JK built from 2007 to 2016, in the trims below.
- 2007–2016 Jeep Wrangler (JK) (70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S, Unlimited 70th Anniversary, Unlimited 75th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S, Unlimited X, X)
It is for 2007-2016 Wrangler (JK) 4-door models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The corners have precut holes for the gas tank and tail light openings, but installation still requires cutting or drilling. Plan for some fitting work and use standard drilling practice.
What’s included
A pair of rear corners in black diamond plate aluminum with cutout holes. Confirm the mounting hardware you need before installing.









