Overview
The Rugged Ridge 11615.11 is a steel body armor cladding set, sold as XHD Armor Cladding, for the 2007-2018 Jeep Wrangler JK. It is available for both 2-door and 4-door JK models, and its alternate part number is RUG11615.11.
Rugged Ridge describes 3 mm thick steel plate that shields the JK’s lower body panels and rocker panels from glancing blows. The cladding has a sectional design that conforms tightly to the contoured surface, and a black textured powder coat that Rugged Ridge says resists rust and corrosion. It secures to the body with the supplied black button-head hardware, and some drilling is required.
It is compatible with OE and aftermarket fender flares and complements the Rugged Ridge Armor Fenders 11615.01 and 11615.02. It carries a 5-Year Limited Warranty.
Key features
- Body armor cladding for the lower body and rocker panels
- 3 mm thick steel plate
- Sectional design that conforms to the contoured surface
- Black textured powder coat
- Supplied black button-head hardware
- Compatible with OE and aftermarket fender flares
- Complements Rugged Ridge Armor Fenders
- 5-Year Limited Warranty
Before you install
Steel body armor covers the lower body and rocker panels, which take the brunt of rock strikes on rough trails. Before fitting cladding, inspect the sheet metal beneath for surface rust and seal any bare spots, since trapped moisture is the usual cause of trouble under armor. Dry-fit the sections and mark the drill points before committing to holes, and check that the hardware sits clear of fuel and brake lines.
Cladding that follows the body contour tends to hold its position better over time, but it still needs periodic checks. Tighten the button-head fasteners after the first few trail runs and again after heavy washing, and look for chipped powder coat along the edges. Touch up small chips promptly with matching paint so moisture does not work under the coating.
- Re-check fasteners after the first trail outings
- Inspect edges for chipped coating
- Plan drill locations before cutting into the body
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11615.11 |
| UPC | 804314295073 |
| Product type | Body armor cladding (fender protector, XHD Armor Cladding) |
| Alternate part number | RUG11615.11 |
| Material | Steel plate, 3 mm thick |
| Finish | Black textured powder coat |
| Hardware | Supplied black button-head hardware |
| Fender flares | Compatible with OE and aftermarket |
| Fit type | Direct fit |
| Installation type | Cutting or drilling required |
| Warranty | 5-Year Limited Warranty |
Vehicle fitment
The 11615.11 cladding fits the 2007-2018 Jeep Wrangler JK in these trims.
- 2007–2018 Jeep Wrangler (JK) (70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S, X)
It fits the 2007-2018 Wrangler JK in 2-door and 4-door form, and it does not fit the TJ, LJ or JL. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The cladding secures with the supplied black button-head hardware, and the body must be drilled during installation. It is compatible with OE and aftermarket fender flares.
What’s included
The cladding secures with the supplied black button-head hardware.














