Overview
The JcrOffroad XJQL-97-FLP is a pair of lower quarter panel armor guards for the rear of a Jeep, made from 3/16 inch steel with a black powder coat. The alternate part number is JCRXJQL-97-FLP.
The guards are custom built in house from 3/16 inch thick high strength steel on CNC production machines. The XJQL-97-FLP is rear only, matches the factory flare, and ends at the rear edge of the Jeep’s sheet metal. It does not integrate with rear bumpers like the add-on quarter panel armor does.
JcrOffroad says installation is bolt on and requires drilling 12 holes. The product is made in the U.S.A., and the manufacturer code is XJQL-97-Flare-PC.
Key features
- Lower quarter panel armor for the rear only
- Made from 3/16 inch steel
- Black powder coat finish
- Matches the factory flare
- Bolt-on installation that requires drilling 12 holes
- Ends at the rear edge of the Jeep’s sheet metal
- Does not integrate with JcrOffroad rear bumpers
- Made in the U.S.A.
Preparing rear body panels
Rear quarter panel armor is bolted to sheet metal that was not designed to carry added weight, so the drilling step matters. Mark hole locations carefully, check behind the panel for wiring, fuel lines and brake lines, and drill with a pilot bit first. Remove burrs before fastening the armor.
Bare steel exposed by drilling can rust quickly, especially in a wheel well area that stays wet. Apply rust-inhibiting primer to cut edges and use a sealant or gasket where armor meets the body. Check the rear flare, tire clearance and panel alignment with the armor test-fitted before final tightening.
Rear quarter armor also changes how the body sits with the rear bumper, tail lamps and fuel filler. Think about access to those parts before fastening the guards, and keep a set of spare fasteners on hand for later repairs.
Specifications
| Brand | JcrOffroad |
|---|---|
| Part number | XJQL-97-FLP |
| UPC | 700007278161 |
| Product type | Lower quarter panel armor (rear side body panel) |
| Alternate part number | JCRXJQL-97-FLP |
| Manufacturer code | XJQL-97-Flare-PC |
| Material | Steel, 3/16 inch thick |
| Finish | Black powder coat |
| Position | Rear only |
| Fit type | Direct fit |
| Installation | Bolt on, requires drilling 12 holes |
| Origin | Made in the U.S.A. |
Vehicle fitment
Verify the year, model and trim against your vehicle before buying, and compare the rear flare to the armor before ordering.
Check the armor against your vehicle’s factory rear flare and sheet metal before ordering.
Installation notes
It is bolt on and requires drilling 12 holes, so the body panels must be drilled. It ends at the rear edge of the sheet metal and does not integrate with rear bumpers.
What’s included
A set of lower quarter panel armor guards in black powder coat steel. Mounting hardware is not included, so plan to source fasteners before installing.
















