Overview
The Omix-ADA 18270.06 is a main eye spring hanger, offered as a direct replacement for front or rear leaf springs. It is sized for one hanger per spring.
The hanger is built to original specifications and comes with a limited five year warranty from Omix-ADA.
Key features
- Main eye spring hanger for front or rear position
- One hanger per spring
- Direct OE replacement design
- Built to original specifications
Installing a spring hanger
A main eye spring hanger holds the front or rear end of a leaf spring to the frame. It carries the spring load through the eye and bushing, so it sees constant stress every time the axle moves. Over time the hanger can crack near the welds, the bolt holes can enlarge, and the bushing inside the spring eye can wear out. Any of these changes the axle position and can make steering or ride feel loose, so the hanger is usually inspected whenever the springs are serviced.
When replacing a hanger, work on one side at a time so the axle stays supported. Clean the frame mounting surface and check that the bolts seat fully before tightening them to the torque in your service manual. Replacing the spring bushings and shackle hardware at the same time is common, because worn parts tend to age together. Test the new hanger by checking spring height and watching for rubbing against the frame during a short drive.
- Inspect welds and bolt holes for cracks
- Replace bushings and hardware with the hanger
- Check spring height on both sides after installation
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18270.06 |
| UPC | 804314014049 |
| Position | Front or rear main eye |
| Quantity | 1 per spring |
| Fit type | Direct Fit |
Vehicle fitment
No vehicle or model years are named for the 18270.06. Match the hanger to your original part before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One main eye spring hanger per spring.









