Overview
The Trail Gear 130304-1-KIT is a Rock Assault power steering pump with pulley, built for ram steering setups. A stock pump delivers 1,300 PSI at only one gallon per minute, which can fall short when a ram and the stock steering run together, especially at low RPMs.
Trail Gear says its Rock Assault pumps put out 1,450 or 1,650 PSI at 4 and 4.5 gallons per minute, respectively, to keep fluid volume up even at idle.
Key features
- Power steering pump with pulley included
- Brand rates it at 1,450 or 1,650 PSI
- Rated flow of 4 and 4.5 gallons per minute
- Trail Gear advises against drilling restrictor plates in a stock pump for more volume, citing pump failure
Ram steering and pump load
A ram steering setup adds load to the pump, especially when the stock steering gear and the ram both draw fluid at low engine speed. A pump with more flow keeps the steering responsive at idle, which is where a stock pump is most often short on volume. Pressure matters less than whether the system keeps fluid moving under load.
Lines, the reservoir and the pulley all work with the pump, so check them after installation. Confirm the belt runs straight through the pulley groove, and check that hoses clear the steering linkage at full lock. Pumps are usually serviced along with the reservoir and fluid whenever the system has been opened up.
- Check belt alignment before the first drive
- Look for leaks at pump fittings after the first run
- Use the fluid type your steering system requires
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 130304-1-KIT |
| UPC | 70000621653 |
| Type | Power steering pump, Rock Assault line |
| Pulley | Included |
| Pressure | 1,450 or 1,650 PSI (brand rating) |
| Flow | 4 and 4.5 gallons per minute |
Vehicle fitment
It fits 1984–1995 Toyota 4Runner (DLX, SR5) and 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo) models.
Toyota models and years outside these listings are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the pulley alignment against your belt path before fitting. Disconnect lines only after the system has been relieved of pressure.
What’s included
The kit is one power steering pump with pulley. Check your existing mounting brackets and hoses against the pump before installing.









