Overview
The Omix-ADA 18010.02 is a power steering pump seal kit for Jeep Cherokee (XJ), Grand Cherokee (ZJ) and Wrangler (YJ) models. It is a direct OE replacement built to original specifications.
It fits 1987–1996 Cherokee XJ, 1993–1996 Grand Cherokee ZJ and 1987–1995 Wrangler YJ models.
Key features
- Pump seal kit for power steering
- Direct replacement design
- Made for XJ, ZJ and YJ Jeep models
- Part number 18010.02 with UPC 804314045128
Pump seals and fluid leaks
The pump shaft seal is the most common source of power steering leaks on these Jeep models, and it usually shows up as fluid around the front of the pump or on the belt. Fluid loss over time can make the pump whine and the steering feel heavier. Before replacing the seal, clean the pump thoroughly so you can see where the fluid is coming from during a test run.
Seal replacement often means removing the pump, so plan for fluid loss and keep a drain pan close. Check the pulley, belt and mounting bolts while the pump is off, since a worn belt or loose bracket can cause noise after the repair. Bleed the system once the pump is back in place and recheck for leaks.
- Clean the pump before testing for leaks
- Check the belt and pulley during the repair
- Bleed the system after reassembly
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18010.02 |
| UPC | 804314045128 |
| Type | Power steering pump seal kit |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1987–1996 Jeep Cherokee (XJ) with Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims, 1993–1996 Jeep Grand Cherokee (ZJ) with Base, Laredo, Limited, Orvis and SE trims, and 1987–1995 Jeep Wrangler (YJ) with Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Grand Cherokee WJ and Wrangler TJ models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the individual seals and gaskets against your pump before starting the repair.









