Overview
The Trail Gear 140103-1 is an outer hub dial O-ring for locking hubs, and it fits the 1984-1995 Toyota 4Runner and the 1979-1995 Toyota Pickup. It is a small rubber seal sold on its own, not a complete hub.
The O-ring sits between the inner and outer hub dials. When it is damaged, Trail Gear warns, water and dust can leak into the hub and the dial may become hard to turn. Swapping in a fresh ring addresses both symptoms without replacing the whole hub.
The job is straightforward and needs snap ring pliers and a 10mm socket. The hub itself and any other seals are not part of this kit.
Because the seal is so small, it is easy to overlook until the hub starts to bind or let in water. Owners of older Toyota trucks who service their hubs regularly often replace the ring at the same time as other hub seals, which keeps the dial turning smoothly.
Key features
- Rubber O-ring for a locking hub dial
- Sits between the inner and outer hub dials
- Keeps water and dust from leaking into the hub
- Damaged rings can make the dial hard to turn
- Direct fit for the 4Runner and Pickup models shown
- Needs snap ring pliers and a 10mm socket
Keeping hub seals dry
Locking hubs live in a wet, dirty place, so the seals around the dial are the first line of defense against water and grit. Check the O-ring whenever the hub is off, looking for flattening, cracks or brittle spots. A ring that has lost its shape will not seal well, even if it still looks intact at first glance. Stiffness in the dial often shows up before a leak does, so turn the dial by hand regularly to notice any change.
When the ring is replaced, the other hub seals and the grease inside the hub deserve the same attention. Clean old grease from the dial faces, inspect the snap rings for bending, and repack the hub with a suitable lubricant. Hubs that are driven through deep water or mud benefit from more frequent checks, since trapped water can speed up rust on the metal parts behind the seal.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140103-1 |
| UPC | 70000621295 |
| Product type | Hub outer dial O-ring |
| Material | Rubber |
| Location | Between inner and outer hub dials |
| Tools named | Snap ring pliers, 10mm socket |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Trail Gear 140103-1 includes: 1984–1995 Toyota 4Runner (DLX, SR5); 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo).
Trail Gear lists only the Toyota 4Runner and the Toyota Pickup within the years above. Other Toyota models such as the Land Cruiser, and later 4Runner generations, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Snap ring pliers and a 10mm socket handle the install. Replace a cracked ring before water gets into the hub body.
Snap ring pliers are needed because the dial assembly is held together with snap rings. Clean the dial faces before fitting the new ring so grit does not damage it, and check that the ring seats evenly between the dials.
What’s included
- One hub dial O-ring, part number 140103-1
Not included: The locking hub itself.









