Overview
The Trail Gear 36 inch Rock Assault axle limit strap, part number 111299-KIT, stops a shock from fully extending during hard articulation. It is made from six layers of 1.75 inch nylon webbing, which Trail Gear describes as minimal-stretch and built for extreme terrain. Trail Gear classes it as universal fit, so the correct strap is chosen by measuring the shock, not the vehicle.
Trail Gear’s sizing rule is simple: the strap should be 1 inch shorter than the shock. Length is measured from the center of the mounting holes and is guaranteed to within +/- 1/4 inch.
Key features
- Six layers of 1.75 inch nylon webbing
- Minimal stretch to protect the shock from full extension
- Zinc-plated 4130 heat-treated chromoly steel buckles
- 1/2 inch mounting holes in each buckle
- Anti-abrasion clips to reduce buckle wear
Setting up the strap
An axle limit strap works only when it is sized correctly from the start. Measure the shock at full compression and full extension, then apply the one inch difference rule before cutting or buying a replacement. A strap that is too long lets the shock travel past its limit, while one that is too short can pull the mounts out of their bushings.
Strap wear follows use. Inspect the webbing for fraying, cuts and glazing after rough runs, and look at the buckles for cracks or deformed holes. Replace worn clips so the buckle wear stays low. Keep the strap away from sharp rock edges where possible, and store it dry to prevent mildew in the nylon.
- Measure the shock before ordering
- Inspect webbing after each hard trail day
- Replace worn clips before they damage buckles
- Check mounting hardware at every service
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 111299-KIT |
| UPC | 70000640919 |
| Length | 36 inch, from the center of the mounting holes, +/- 1/4 inch |
| Webbing | 1.75 inch nylon, six layers |
| Strength | 9,000 lb. test nylon |
| Buckles | 4130 heat-treated chromoly steel, zinc-plated |
| Mounting holes | 1/2 inch |
| Clips | Anti-abrasion clip in each buckle |
Vehicle fitment
Fitment is universal and no vehicle is named, so this strap is not matched by year or model. Match it to the length of the shock it will limit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Select the strap after measuring the shock, using the 1 inch difference. Verify that the 1/2 inch mounting holes accept the hardware you plan to use.
What’s included
One 36 inch limit strap with buckles and anti-abrasion clips installed in each buckle.





