Overview
The Smittybilt D1098CC is a gloss black nerf step set for the Dodge Ram 2500 and 3500. It fits the 2010 Ram 2500 in Laramie, Power Wagon, SLT, ST, SXT and TRX versions and the 2010 Ram 3500 in Laramie, SLT and ST. It also fits the 2011 to 2016 Ram 2500 and 3500 in the trims covered for those years.
The step is a 4 or 6 step drop-down design built from a 3-inch main tube. Cleated step plates give a firm footing, and the unit is rated for loads of up to 445 pounds. Its higher ride height suits lifted trucks, where the step sits well off the ground.
The step is a one-piece unit that bolts onto the frame. No brackets need to be assembled beforehand, which keeps installation short for a home mechanic.
Key features
- Gloss black finish
- Wheel-to-wheel length
- Four or six step drop-down design
- Three-inch main tube
- Cleated step plates
- Rated for loads up to 445 pounds
- One-piece bolt-on unit
- Helps protect rocker panels
Choosing the right setup
A nerf step fills the gap between the wheels and gives a usable entry point when a truck sits high off the ground. Drop height matters most. A step that hangs too low can catch on rocks and brush, while one set too high is hard to reach. Measure your tire size and ride height before deciding, and consider how often you climb in and out with gear or passengers.
Once a one-piece frame-mounted step is in place, the frame attachment carries most of the load. Re-check the fasteners after the first few trail runs and again after any tire or suspension change, since vibration and flex can loosen them. Inspect the cleated plates for bends or cracks after hard use, and rinse off packed mud that can hide damage.
- Check clearance to tires at full steering lock
- Look at the drop height against your rocker and sill
- Keep a torque wrench and spare fasteners on hand
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | D1098CC |
| Finish | Gloss black |
| Length | Wheel to wheel |
| Main tube | 3 inches |
| Step design | Four or six step drop-down with cleated plates |
| Load rating | Up to 445 pounds |
| Installation | One-piece unit bolts to frame |
Vehicle fitment
It fits the 2010 Dodge Ram 2500 and 3500 and the 2011 to 2016 Ram 2500 and 3500 in the trims covered for each year. The Ram 1500, 2009 Ram trucks and 2017 and later Ram trucks are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
The Ram 1500, the 2009 Ram trucks and the 2017 and later Ram trucks are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One nerf step unit. Count the parts on arrival against your installation plan first.
















