Overview
The Smittybilt GEN2 SRC Rear Bumper, part number S/B77714, is a powder-coated steel rear bumper for the 2018–2026 Jeep Wrangler (JL). It has a class III, 2-inch receiver hitch built into the bumper, two reverse lights and D-ring mounts. The Gen2 design is a redesign of the SRC for greater fender-to-fender protection.
The bumper is made from 3/16-inch cold rolled steel, and its corners extend to match the factory fender lines. The bottom and sides are reinforced with replaceable PP+TPO slip strips. The D-ring mounts are solid, welded inside and out, with an integrated recovery point.
Key features
- Class III, 2-inch receiver hitch incorporated into the bumper
- Two reverse lights
- Solid D-ring mounts with integrated recovery points
- Replaceable PP+TPO slip strips add 5/16 inch of damage protection
- Corners that extend to match the factory fender lines
Installation checks
Rear bumpers with a built-in hitch carry tongue weight and cargo, so the mounting points matter as much as the bumper itself. Before installing, confirm the hitch bolts line up with the factory mounting points and that no wiring or sensor is pinched. Take your time with the fasteners and check alignment before tightening them fully.
Sensors near the bumper can be sensitive to damage during removal, so handle them carefully. Use the correct sockets and retainers for your trim, and keep sensor wiring clear of sharp edges and the hitch tube. After installation, test the reverse lights and check that the sensors respond as expected.
- Match sockets and retainers to your trim
- Check alignment before final torque
- Route wiring away from the hitch tube
- Test lights and sensors after mounting
- Re-check hitch bolts after first towing trip
Specifications
| Brand | Smittybilt |
|---|---|
| Model | GEN2 SRC Rear Bumper |
| Part number | S/B77714 |
| Position | Rear |
| Material | Steel, 3/16″ cold rolled |
| Finish | Powder coat |
| Receiver hitch | Included, class III, 2-inch |
| Reverse lights | Two |
| D-ring mounts | Included |
| Tire carrier | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2018–2026 Jeep Wrangler (JL), in both 2-door and Unlimited 4-door models.
The list does not include the Gladiator, the Wrangler JK or any model year before 2018 or after 2022. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The hitch bolts directly to the factory mounting points. On a Sport or Sahara with a plastic bumper, OE Rubicon sensor sockets and retainers are needed, since those sensors cannot be removed.
What’s included
The GEN2 SRC rear bumper with its receiver hitch, two reverse lights and D-ring mounts.
The class III, 2-inch receiver hitch is built into the bumper, so it is part of the bumper rather than a separate add-on.





















